User manual EPSON STYLUS PRO 10000CF CANVAS PAPER GUIDE

[. . . ] 27 1 English Printer Parts Front view roll paper spindles roll paper cover paper lever mounting brackets control panel paper basket ink cartridge compartment front cover Rear view IEEE1394 interface connector USB interface connector AC inlet Optional interface card slot cover All rights reserved. No part of this publication may be reproduced, stored in a retrieval system, or transmitted in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, without the prior written permission of Seiko Epson Corporation. The information contained herein is designed only for use with this Epson printer. Epson is not responsible for any use of this information as applied to other printers. [. . . ] Make sure the joints are positioned as shown. 4. Set 2 paper guides at the bottom of the printer as shown below, when you feed the paper forward or backward. Reusing the Packaging If you need to transport your printer a long distance, the printer should be repacked using the original boxes and packing materials. Contact your dealer for assistance. 16 Setting up the Printer Connecting the Power Cord Note: Most illustrations shown in this section are for EPSON Stylus Pro 9800/9400, so they may vary in appearance from EPSON Stylus Pro 7800/7400. The instructions are the same, except as noted. Check the label on the back of the printer to make sure the voltage required by the printer matches that of the wall outlet. Also, make sure that you have the correct power cord for your power source. c Caution: It is not possible to change the printer's voltage. If the rated voltage and your outlet voltage do not match, do not plug in the power cord, and contact your dealer for assistance. 4. Plug the power cord into a properly grounded electrical outlet. c 2. Connect the power cord to the AC inlet on the back of the printer. Caution: Do not use an outlet that is controlled by an automatic timer or wall switch. Otherwise, accidental shut down or damage to your printer may occur. Installing the Ink Cartridges To install the ink cartridges, follow the instructions below. w Warnings: The ink cartridges are self-contained units. Under ordinary use, ink will not leak from the cartridges. Slide the movable flange off the end of the spindle. 19 English 6. After inserting all ink cartridges in their corresponding slot, lower the ink levers. The printer starts initial ink charging. 2. Place the roll paper on a flat surface so that it unwinds in the direction shown. Slide the roll paper onto the spindle and fully onto the fixed flange. 6. Make sure that the Power light is not flashing, and then set the paper lever to the released position. LOAD PAPER appears on the LCD panel. Adjust the feed strength by pressing the Paper Feed buttons on the control panel. When using thick, heavy, or curled paper, press the Paper Feed u button to increase the power. When using thin or light paper, press the Paper Feed d button to decrease the power. c Caution: Do not set the paper lever to the released position while the Power light is flashing. Insert the paper into the paper insertion slot. If the paper does not come out even after executing the procedure above, open the front cover and pull the paper out manually. Holding the bottom edge of the paper, turn the roll paper to remove slack. [. . . ] For USB interface users, click your printer's icon and the port your printer is connected to. For IEEE 1394 interface users, click your printer's icon and the FireWire port your printer is connected to. Select the appropriate Background Printing radio button to turn background printing on or off. With background printing on, you can use your Macintosh while it is preparing a document for printing. [. . . ]