User manual EPSON STYLUS PHOTO R285

[. . . ] No part of this publication may be reproduced, stored in a retrieval system, or transmitted in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, without the prior written permission of Seiko Epson Corporation. The information contained herein is designed only for use with this product. Epson is not responsible for any use of this information as applied to other printers. Neither Seiko Epson Corporation nor its affiliates shall be liable to the purchaser of this product or third parties for damages, losses, costs, or expenses incurred by the purchaser or third parties as a result of accident, misuse, or abuse of this product or unauthorized modifications, repairs, or alterations to this product, or (excluding the U. [. . . ] See the online User's Guide when using Legal size paper. Do not load paper above the H arrow mark inside the edge guide. Do not try to force the card all the way into the slot. If the memory card needs an adapter then attach it before inserting the card into the slot, otherwise the card may get stuck. You can copy one photo or multiple photos of different sizes at the same time, as long as they are larger than 30 × 40 mm. Make sure you set the Paper Type and Paper Size. If you scanned two photos, repeat step G for the second photo. Make sure you set the Paper Type and Paper Size. Make sure you have installed software for this printer on your computer and connected following the instructions on the Start Here Poster. After selecting a PC, your computer's scanning software automatically starts scanning. Print quality may decline in the top and bottom areas of the printout, or the area may be smeared when printing. Cannot recognize the memory card or disk. R & 61 R & 20 Turn the printer off and then back on. Make sure that no paper is still in the printer. if the error message still appears , contact Epson support. if the error message still appears , contact Epson support. Contact Epson support to replace ink pads before the end of their service life. When the ink pads are saturated, the printer stops and Epson support is required to continue printing. contact Epson support to replace ink pads. Make sure the memory card or storage disk has been inserted correctly. If so, check to see if there is a problem with the card or disk and try again. If the error message still appears, make sure that scanning software is installed on your computer and that the software settings are correct. [. . . ] O When an ink cartridge is expended, you cannot continue printing even if the other cartridges still contain ink. Never open the cartridge cover while the print head is moving. Be careful not to break the hooks on the side of the ink cartridge. If you find it difficult to close the cover, press down on each cartridge until it clicks into place. [. . . ]