User manual EPSON STYLUS PRO 4880C

[. . . ] User's Guide NDP2997-00 Copyrights and Trademarks No part of this publication may be reproduced, stored in a retrieval system, or transmitted in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, without the prior written permission of Seiko Epson Corporation. The information contained herein is designed only for use with this Epson printer. Epson is not responsible for any use of this information as applied to other printers. Neither Seiko Epson Corporation nor its affiliates shall be liable to the purchaser of this product or third parties for damages, losses, costs, or expenses incurred by the purchaser or third parties as a result of accident, misuse, or abuse of this product or unauthorized modifications, repairs, or alterations to this product, or (excluding the U. S. ) failure to strictly comply with Seiko Epson Corporation's operating and maintenance instructions. [. . . ] Press the Menu setting, and THICKNESS PAT appears on the LCD panel. Press the Menu button again to print the paper thickness test printing pattern. Paper thickness test pattern example: 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 smallest gap 9. Examine the printed pattern to determine which set of lines are aligned (showing the smallest gap), and note the corresponding number. After the pattern is printed, THICKNESS NUM appears. Press the Paper Feed or Paper Feed button to select the number noted in step 9. Press the Menu button to save the selected value. 12. Press the Paper Feed or Paper Feed button to select STANDARD, THICK, SLOW, THICK, FAST, or THIN PAPER, and then press the Menu button. Press the Paper Feed or Paper Feed button to set the paper feed amount, and then press button. Select AUTO, SHEET, ROLL CURLED, or button. ROLL NORMAL, and then press the Menu The Control Panel 184 15. Press the Paper Feed or Paper Feed button to select the time in seconds, and then press button. Press the Paper Feed or Paper Feed button to select STANDARD, -1, -2, -3, or -4. Press the Paper Feed or Paper Feed button to adjust MicroWeave. Increase the value to give priority to the print speed, or decrease it to give priority to the print quality. Press the Menu button to save the selected value. Selecting the registered settings To select the registered settings, follow the steps below. Press the Menu button to enter Menu mode. Press the Paper Feed or Paper Feed CUSTOM PAPER, and then press the Menu 3. Press the Paper Feed or Paper Feed PAPER NUMBER, and then press the Menu 4. Press the Paper Feed or Paper Feed button to select the number registered that you want to use. If you select STANDARD, the printer prints data according to the driver settings. X, the control panel settings override the driver settings. [. . . ] A serial interface transmits data one bit at a time. interface cable The cable that connects between the computer and the printer. LCD Liquid Crystal Display. Shows various messages according to status of the printer. local printer The printer which is connected to the computer's port directly by interface cable. media Materials upon which data is printed, such as roll paper and cut sheets, plain paper, and special paper. memory The part of the printer's electronic system that is used to store information (data). Some information is fixed and is used to control how the printer operates. Information that is sent to the printer from the computer is stored in the memory temporarily. [. . . ]