User manual EPSON SURECOLOR SC-P5000 SETUP GUIDE (1.0)

[. . . ] ❏ Do not install or store the printer in an unstable location or a location subject to vibrations from other equipment. ❏ Do not install the printer in locations subject to oily smoke and dust, or in locations subject to humidity or where it could easily get wet. ❏ Do not tilt the product more than 10 degrees forward, back, left, or right while moving it. ❏ Because the product is heavy, it should not be carried by one person. [. . . ] ❏ Use only an outlet that meets the power requirements of this printer. ❏ Operate the printer under the following conditions: Temperature: 10 to 35°C Humidity: 20 to 80% without condensation Even the conditions above are met, you may not print properly if the environmental conditions are not proper for the paper. See the instructions of the paper for more detailed information. Keep the printer away from drying, direct sunlight, or heat sources to maintain the appropriate humidity. See the User’s Guide (PDF) for more information. Moving the printer requires two persons, who must use the hand-holds on either side. Carrying the Printer Déplacement de l’imprimante Tragen des Druckers De printer dragen Trasporto della stampante Transporte de la impresora Transportar a Impressora 8 EN Initial Ink Charging IT Ricarica di inchiostro iniziale FR Chargement initial en encre ES Carga inicial de tinta DE Initiale Tintenfüllung PT Carregamento Inicial de Tinta NL Eerste keer inkt bijvullen [4] [5] [6] [7] [8] 9   English  /  Français  /  Deutsch  /  Nederlands  /  Italiano  /  Español  /  Português  [1] [2] [3] EN Initial Ink Charging FR Chargement initial en encre DE Initiale Tintenfüllung NL Eerste keer inkt bijvullen IT Ricarica di inchiostro iniziale ES Carga inicial de tinta PT Carregamento Inicial de Tinta [9] The paper cassette cover is not used when printing on roll paper or on cut sheets A3 or smaller. Store the cover at the bottom front of the printer. Aviso: Use only the type of power source indicated on the printer’s label. 10 EN Initial Ink Charging FR Chargement initial en encre DE Initiale Tintenfüllung NL Eerste keer inkt bijvullen IT Ricarica di inchiostro iniziale ES Carga inicial de tinta PT Carregamento Inicial de Tinta [12] Turn the printer on and choose from the light gray or violet ink sets. [13]   English  /  Français  /  Deutsch  /  Nederlands  /  Italiano  /  Español  /  Português  11 [14] ❏❏ After opening the ink cartridge, be sure to shake it as shown in the figure. ❏ Do not touch the IC chip on the cartridge. Doing so may cause incorrect operation or printing. EN Initial Ink Charging FR Chargement initial en encre DE Initiale Tintenfüllung NL Eerste keer inkt bijvullen IT Ricarica di inchiostro iniziale ES Carga inicial de tinta PT Carregamento Inicial de Tinta [15] Install ink cartridges in all slots as described in the label inside the ink cover. [16] A over the ink icon in the control panel indicates that the wrong option may be chosen for Select Ink Set. Turn the printer off and then on again and select the correct inkset. 13   English  /  Français  /  Deutsch  /  Nederlands  /  Italiano  /  Español  /  Português  Observe the following precautions when charging the ink. If these precautions are not observed, the work may be interrupted and require redoing, resulting in more ink being consumed than normal. ❏ Do not disconnect the power cable from the outlet or turn off the power. ❏ Do not perform operations other than those specified on the screen. [. . . ] Insert the supplied software disc into your computer, and then follow the on-screen instructions to install. For Mac OS X or computers that do not have a disc drive, access <http://epson. Sn/>, search for this printer, and install the software and manuals. The method for displaying the PDF manuals differs depending on the operating system as shown below. [. . . ]