User manual EPSON SURECOLOR SC-T7000 HARD DISK UNIT

[. . . ] All rights reserved. 2 SC-F6000 Series User’s Guide Contents Contents Copyrights and Trademarks Introduction Important Safety Instructions. 5 When choosing a place for this product. 15 Notes on Handling Ink Packs and Ink Tanks . 19 Saving Optimal Settings for the Current paper (Print Paper Settings). [. . . ] Depending on the ink density or paper type, the ink may take a while to dry. If the ink blurs on the paper, set a longer time for drying the ink. The longer the drying time, the more time required for printing. Paper Size Check On Off Choose whether the printer automatically detects (On) or does not detect (Off) the paper width. Try choosing Off if a paper setting error is displayed when the paper is correctly loaded. Note, however, that the printer may print outside the paper when Off is selected. If it prints beyond the edges of the paper, the inside of the printer becomes dirty with ink. We generally recommend to operate with this setting set to On. If On is selected, an error will be displayed in the control panel and printing will stop if the paper is skewed; select Off to disable this feature. On is recommended in most circumstances as skewed paper may cause the printer to jam. Select when to perform scheduled head cleaning; you can select from Off or after every 1 to 10 pages. Choose a paper type that matches the paper in the printer. Confirm that the printer is ready to print. Confirm that Nozzle Check is highlighted and press the Z button. A confirmation dialog will be displayed. Press the Z button to print a check pattern. Review the printed check pattern while referring to the following section. Example of clean nozzles U “Cleaning the print head” on page 46 At first, use Execute (Light). If you still notice any faint or missing areas, then use Execute (Medium) or Execute (Heavy). Adjusting the print head position (Print head alignment) Perform Head Alignment if lines are misaligned or print results are grainy. The Head Alignment function corrects print misalignments. There are no gaps in the nozzle check pattern. Example of clogged nozzles U “Minimizing Print Misalignments (Head Alignment)” on page 46 If there are areas missing from the pattern, select Head Cleaning and clean the print head. U “Cleaning the print head” on page 46 45 SC-F6000 Series User’s Guide Maintenance Cleaning the print head From the control panel you can clean all nozzles or select to clean only those nozzles for which the printed nozzle check pattern indicates a problem. B C Press the d/u buttons to highlight Head Cleaning and press the Z button. [. . . ] Failure by Apple or any Contributor to enforce any provision of this License will not be deemed a waiver of future enforcement of that or any other provision. Any law or regulation which provides that the language of a contract shall be construed against the drafter will not apply to this License. (a) If for any reason a court of competent jurisdiction finds any provision of this License, or portion thereof, to be unenforceable, that provision of the License will be enforced to the maximum extent permissible so as to effect the economic benefits and intent of the parties, and the remainder of this License will continue in full force and effect. (b) Notwithstanding the foregoing, if applicable law prohibits or restricts You from fully and/or specifically complying with Sections 2 and/or 3 or prevents the enforceability of either of those Sections, this License will immediately terminate and You must immediately discontinue any use of the Covered Code and destroy all copies of it that are in your possession or control. [. . . ]