User manual EPSON TM-P60II

[. . . ] The following standards are applied only to the printers that are so labeled. (EMC is tested using EPSON power supplies. We, Seiko Epson Corporation, hereby declare that the equipment Models, M292A and M292B, are in compliance with the essential requirements and other relevant provisions of Directive 1999/5/EC. wARNING The connection of a non-shielded printer interface cable to this printer will invalidate the EMC standards of this device. [. . . ] Do not allow water to contact the terminals. The caution label on the product indicates the following precaution. cAUTION: During printing or after printing, the thermal head can be very hot. When this product is used for applications requiring high reliability/safety, such as transportation devices related to aviation, rail, marine, automotive, etc. ; you should use this product only after giving consideration to including fail-safes and redundancies into your design to maintain safety and total system reliability. Because this product was not intended for use in applications requiring extremely high reliability/safety, such as aerospace equipment, main communication equipment, nuclear power control equipment, or medical equipment related to direct medical care, etc. , please make your own judgment on this product's suitability after a full evaluation. The printer does not operate with only the AC adapter. Always install the enclosed battery OT-BY60II in the printer even when using the AC adapter. Be sure to use the power switch to turn the printer on and off. To communicate with a computer via a USB cable, connect the cable before Turning on the printer. to use the USB cable , it is recommended to secure it to avoid stress on it. Be sure not to open the roll paper cover when the printer is operating. Do not apply excessive force to the printer case. Do not place food or beverages such as coffee on the case of the printer. For Bluetooth interface models, when the wireless connection is ended while the For Bluetooth interface models, if you establish a radio connection between the host computer and the printer each time you start printing instead of maintaining the connection, it may take a while between the time you send a print job and the time that the printer actually starts printing. This happens because connecting the host computer and the printer requires some time. The time required for connection depends on the operating environment. for American Users WARNING: The cords included with this product contain chemicals, including lead, known to the State of California to cause birth defects or other reproductive harm. (This notice is provided in accordance with Proposition 65 in Cal. Before using the printer for the first time, charge the battery OT-BY60II. To install and charge the battery, see "Installing and Charging Battery. [. . . ] When the printer power is on, if the Error LED and the Charge LED are on, the remaining battery charge is not enough for printer operation. When the battery is being charged, if the Error LED is on, an abnormality has The battery must be replaced with a new one. Turn off the power, wait several seconds, and then turn it on again. CAUTION: After printing, the thermal head can be very hot. [. . . ]