User manual EPSON WORKFORCE PRO WF-8010 DW NETWORK ADMINISTRATOR'S GUIDE

[. . . ] Safety indications The documentation and this product use graphical symbols to show how to use this product safely. The indications and their meaning are as follows. Make sure you understand them properly before reading the guide. Symbol Warning Caution Explanation This symbol indicates information that, if ignored, could possibly result in personal injury or even death due to incorrect handling. [. . . ] Caution • Do not wire the Touch Unit connection cable into the wall. If it is wired into the wall, it cannot be connected to the Touch Unit. € Take care not to trap the cables between the setting plate and wall plate. 30 Installation Guide c Secure the setting plate and the wall plate Secure the supplied M6 screws (x3) with a commercially available No. 3 cross-head screwdriver, and then lightly tighten the supplied M6 bolt (x1) with the spanner. D Adjust the vertical slide with the open-ended spanner, and align it with the standard position ( ) • Tightening the hexagonal axis at the top ( • Tightening the M8 bolt at the bottom ( ) raises the setting plate, and loosening the axis lowers it. ) lowers the setting plate, and loosening the bolt raises it. 31 Installation Guide e Tighten the M6 bolt (x1) to fix the setting plate in position Securing the projector to the setting plate a Loosen the screws (x2) and remove the cable cover from the projector b Insert the slide plate into the setting plate from the interface side of the projector 32 Installation Guide c Align the 3-axis adjustment unit with the slide plate's standard position ( ( ) indicates the screw holes for the bolts. ) d Tighten the supplied M4 bolts (x2) e Connect the cables to the projector 33 Installation Guide c • Connect the power cord last. € When connecting to the Audio1, Audio2, and Computer1 ports, we recommend connecting cables to the ports in the following order: Audio1, Audio2, and then Computer1. Adjusting the Projected Image Follow the procedures below to adjust the projected image. After you finish making adjustments, tighten the M6 bolt that you loosened. K Make sure that all of the bolts that you loosened in steps 5 to 10 are securely tightened Warning Tighten all bolts and screws firmly. Otherwise, the product may fall and cause personal injury or property damage. L a Press the [Esc] button on the remote control or the control panel to remove the guidance screen Fine-tuning the Focus Turn on the projector, and then press the [Menu] button Using the Remote Control Using the Control Panel 39 Installation Guide b Select Pattern from Settings c Select Test Pattern When displaying on a 4:3 screen, set Pattern Type to Pattern 5, and then select Pattern Display. 40 Installation Guide d Adjust the focus to match the focus in the following figure ( Open the air filter cover, and then adjust the focus. s "Adjusting the Projection Position" p. 34 ) ) is in focus, check the ( When ( ) areas are uniform. If any of the ( ) areas are out of focus, adjust the focus After you finish making adjustments, close the air filter cover. E Press the [Esc] button on the remote control or the control panel to remove the Test Pattern Calibrating the pen Check that adjusting the projected image is complete before you start calibrating the interactive pen. s "Adjusting the Projected Image" p. 34 There are two methods available for calibrating the pen; Auto Calibration and Manual Calibration. [. . . ] The projector is recognized as a removable disk by the computer. d Copy the batch setup file (PJCONFDATA. Bin) that you saved to your computer to the toplevel folder of the removable disk c Do not copy any files or folders other than the batch setup file to the removable disk. E Perform "Remove USB device" on your computer, and then disconnect the USB cable c When using OS X, perform "Remove EPSON_PJ". [. . . ]