User manual EPSON X860DE

[. . . ] 45 Changing port settings after installing a new network Internal Solutions Port. 60 Loading letter‑ or A4‑size paper in the short-edge orientation. 198 Cleaning the exterior of the printer. 215 Adjusting the brightness of the display. [. . . ] It uses the default printer language specified in the Setup menu if the PCL SmartSwitch setting is Off. NPA Mode Auto Off Sets the printer to perform the special processing required for bidirectional communication following the conventions defined by the NPA protocol Notes: • Auto is the factory default setting. € Changing this setting from the printer control panel and then exiting the menus causes the printer to restart. USB Buffer Auto Disabled 3K to <maximum size allowed> Sets the size of the USB input buffer Notes: • Auto is the factory default setting. • The Disabled setting turns off job buffering. Any jobs already buffered on the disk are printed before normal processing is resumed. € The USB buffer size value can be changed in 1‑K increments. € The maximum size allowed depends on the amount of memory in the printer, the size of the other link buffers, and whether the Resource Save setting is On or Off. € To increase the maximum size range for the USB Buffer, disable or reduce the size of the parallel, serial, and network buffers. € Changing this setting from the printer control panel and then exiting the menus causes the printer to restart. Understanding printer menus 145 Menu item Job Buffering Off On Auto Description Temporarily stores jobs on the printer hard disk before printing Notes: • Off is the factory default setting. • The On setting buffers jobs on the printer hard disk. € The Auto setting buffers print jobs only if the printer is busy processing data from another input port. € Changing this setting from the printer control panel and then exiting the menus causes the printer to restart. Mac Binary PS Auto Off On Sets the printer to process Macintosh binary PostScript print jobs Notes: • Auto is the factory default setting. Sets the network address, netmask, or gateway information for an external print server that is attached to the printer using a USB cable. Note: This menu item is available only if the printer is attached to an external print server through the USB port. USB With ENA ENA Address ENA Netmask ENA Gateway Network Reports menu This menu is available from the Network/Ports menu: Network/Ports > Standard Network or Network <x> > Std Network Setup or Net <x> Setup > Reports or Network Reports Menu item Print Setup Page Print NetWare Setup Page Description Prints a report containing information about the current network setup Notes: • The Setup Page contains information about the network printer settings, such as the TCP/IP address. € The NetWare Setup Page menu item appears only on models that support NetWare and shows information about NetWare settings. Network Card menu This menu is available from the Network/Ports menu: Network/Ports > Standard Network or Network <x> > Std Network Setup or Net <x> Setup > Network Card Menu item View Card Status Connected Disconnected Description Lets you view the connection status of the Network Card Understanding printer menus 146 Menu item View Card Speed Network Address UAA LAA Job Timeout 0‑225 seconds Description Lets you view the speed of a currently active network card Lets you view the network addresses Sets the amount of time in seconds that a network print job can take before it is canceled Notes: • 90 seconds is the factory default setting. • A setting value of 0 disables the timeout. € If a value of 1–9 is selected, then the setting is saved as 10. [. . . ] At the IETF for Elliptic Curve Cryptography (ECC) Cipher Suites for Transport Layer Security (TLS) implemented in the product or service. The use of this product or service is subject to the reasonable, non-discriminatory terms in the Intellectual Property Rights (IPR) Disclosure of Certicom Corp. At the IETF for TLS Elliptic Curve Cipher Suites with SHA-256/382 and AES Galois Counter Mode (GCM) implemented in the product or service. The use of this product or service is subject to the reasonable, non-discriminatory terms in the Intellectual Property Rights (IPR) Disclosure of Certicom Corp. [. . . ]