User manual ESCALADE SPORTS 2L-4106-01

[. . . ] OWNER'S MANUAL TABLE TENNIS TABLE Questions, Concerns, Comments?Need Product Assistance? Escalade Sports, a diversified manufacturer of fine sporting goods equipment, is here to help you in any way possible to make your experience with this product a pleasurable one for you and your family. We always try hard to make sure that our products are manufactured free from defects in material and workmanship to provide a lifetime of family fun. If you find any problems with your new product such as missing parts, damaged parts, or incorrectly manufactured parts, MODEL NOs. [. . . ] DO NOT HIT CASTER SOCKET DIRECTLY WITH A HAMMER!SET A PIECE OF WOOD ON CASTER SOCKET AND HIT PIECE OF WOOD TO DRIVE CASTER SOCKET INTO USUPPORT. Insert casters #11 into caster sockets #12. 16. CAUTION: AT LEAST TWO ADULTS ARE NEEDED TO MOVE TABLE HALF! 17. Prepare an area for the assembly of the second table top half. If necessary, move the first table top half aside with the aid of a helper. Be sure to place it in a location where it won't be disturbed or damaged. If setting on its side, be sure to place the bottom edge no less than 12 inches away form the wall. Also be sure to place carpet or pieces of the shipping carton down to protect table top edges. If floor is not carpeted, brace table top half with a heavy object to keep it from sliding. Repeat steps 1 through 12 on second table half. Gently tap caster sockets #12 into U-support #7 on second table half until flange on sockets touches the edge of the tube. DO NOT HIT CASTER SOCKETS TOO HARD WITH A HAMMER. Insert casters #11 into caster sockets #12 on second table half. Attach linkages #4 to the OUTSIDE of U-support #7 on second table half. Use screws #14, plastic washers #24 and hex nuts #15. NOTE: Tighten locknuts #15 finger tight only. They will be removed when the two table top halves are connected. Figure 9 CAUTION: AT LEAST TWO ADULTS ARE NEEDED TO COMPLETE THE REMAINDER OF THE ASSEMBLY! 5 Figure 10 22. Make sure the legs on the first table top half (the half with the name panel #5) are open. With one person on each side of the table, lift and set table half on its legs. Place table against a wall as shown above to help stabilize table top half while second half is being attached. Be sure there is enough room to connect second half. CAUTION: BE SURE THE FIRST TABLE HALF YOU ASSEMBLED (WITH NAME PANELS #5 ATTACHED) IS STABLE AND AGAINST A WALL. DO NOT LEAVE TABLE HALF STANDING UNATTENDED. 23. [. . . ] Check to be sure that table half is locked in the safety latch. Repeat for the other table half. 7 CARE AND MAINTENANCE You have purchased a quality product that will give you years of enjoyment. By following these simple maintenance steps, you will add to the life of your new table. THE TABLE TOP The top (playing surface) of your table is made of particle board. [. . . ]