User manual ESCALADE SPORTS 2L-4112-00

[. . . ] Some smaller parts may be shipped inside larger parts. Check inside all parts and cartons before assembling or ordering parts. Do not tighten hardware until instructed to do so. If hardware is tightened too soon, mounting holes may not align and parts may not easily fit together. [. . . ] Some states do not allow the exclusion or limitation of implied warranties or consequential or incidental damages, so the above limitations or exclusions may not apply to you. LEGAL REMEDIES: This warranty gives you specific legal rights and you may also have other rights which may vary from state to state. CARE AND MAINTENANCE You have purchased a quality product that will give you years of enjoyment. By following these simple maintenance steps you will add to the life of your new table. The top (playing surface) of your table is of aluminum construction. It can be affected by atmospheric conditions, meaning both temperature and humidity. This may cause a slight sag or distortion as top expands or contracts. This is normal and should not cause concern as it does not detract from the play or utility value of the table. STORAGE OF YOUR TABLE Wind gusts can blow over or unexpectedly open the table; Store in protected area. When your table is not in use, it should be folded up in a dry area. CLEANING YOUR TABLE To clean your table use a soft damp NOT WET cloth only. To prevent damage to your table's playing surface DO NOT use any chemicals, abrasive, or cleaning products on your table's playing surface. IMPORTANT: Periodically, lubricate all moving parts, including pivot points, to assure smooth opening and closing. A light lubricant such as WD-40 is recommended. UNLEVEL TABLE If table does not seem level, it is more than likely because the floor is not level. Move table several inches (set table in playing position) in different directions to find the best location for the table. If the floor is extremely unlevel, table may not play or operate properly. If table is high in the center, shim up under the outer legs. 2 READ AND FOLLOW ALL ASSEMBLY, OPERATING, AND SAFETY INSTRUCTIONS CAREFULLY. AT LEAST TWO (2) ADULTS ARE NEEDED TO PUT THIS TABLE TOGETHER! 1. Position caster rails (#1) on the floor as shown approximately 30 inches apart. Figure 1 AT LEAST TWO (2) ADULTS ARE NEEDED TO COMPLETE THE REST OF THIS ASSEMBLY! Figure 2 2. With another adult holding table top (#5) upright, attach ends of "H"-support tube with top of pivot tubes on caster rails (#1). Repeat this process for the other caster rail. [. . . ] Do NOT touch any parts on bottom of table while opening and closing. Figure 5 TO CLOSE: 1. Remove net and net posts from table. PLAYBACK POSITION Figure 3 2. Open other table half as in step 1 and 2. Lift table half to midpoint until the safety clips are engaged. [. . . ]