User manual ESCALADE SPORTS 2L-6433-00

[. . . ] IMPORTANT NOTE: If floor is not carpeted, be sure to place a heavy object at the base of the table half to help prevent table half from sliding away from wall. Pull legs #2 & #3 out from table and lock their hinges by pulling hinges upward as shown in figure 1, detail. Put caps #13 on ends of both legs #2 & #3. Rotate U-support #7 until you see the screw hole in the slot of U-clip #6 (See Figure 1, Detail). [. . . ] Insert one caster #11 into each caster socket #12. (See Figure 5, detail) Figure 6 Connecting Two Table Halves Figure 7 BE SURE HINGES ON LEGS ARE LOCKED BEFORE STANDING TABLE HALF UPRIGHT!BE SURE THE FIRST TABLE HALF YOU ASSEMBLED (WITH U-BRACES #5 ATTACHED) IS STABLE AND AGAINST A WALL. DO NOT LEAVE TABLE HALF STANDING UNATTENDED. 22. Make sure legs on the table half with the U-braces #5 (the first half you assembled) are open and their hinges are locked. With one person on each side of table, lift and set table half on its legs. Place table against a wall as shown above to help stabilize table half while second half is being attached. Be sure there is enough room to connect second half. Place two hex bolts #18 and locknuts #16 on floor next to caster wheels (both sides of table half) so they will be handy for the next step. With a person on both sides of second table half (the half without U-braces #5), slide second table half against first table half. Align holes in U-braces #5 with holes in U-support #7. Secure with hex bolts #18 and locknuts #16. Do not tighten 4 nuts until after step #25. (See Figure 7) Safety Latches Figure 8 25. Remove locknuts #15 from screws #14 on second table half, where U-support #7 and linkages #4 join. Slide braces #9 on screws #14 and replace locknuts #15. Tighten nuts snug, but do not overtighten. (See Figure 8) Also, go back and tighten nuts used in step #24. 26. Attach a safety latch #8 to brace tube #9 as shown above, making sure the flange on the safety latch extends over brace tube #9. Secure safety latches #8 to brace #9 with screws #10 and locknuts #15. Repeat for opposite brace tube. INSTALL SAFETY LATCHES #8 AS SHOWN ABOVE FOR PROPER USE OF TABLE!DO NOT OPERATE TABLE UNTIL ASSEMBLY IS COMPLETE! Paddle Rack Mounting Figure 9 28. [. . . ] This may cause a slight sag or distortion as top expands or contracts. This is normal and should not cause concern as it does not detract from the play or utility value of the table. To help minimize this problem, store table in folded up position in a dry area when not in use. STORAGE OF YOUR TABLE This table must be stored indoors to prevent damage to the playing surface. Dampness and extreme temperature changes can cause the wood to warp, swell, crack, or blister. [. . . ]