User manual ESCALADE SPORTS 2L-6441-02

[. . . ] OWNER'S MANUAL MANUAL WARNING FAILURE TO FOLLOW THESE WARNINGS MAY RESULT IN SERIOUS INJURY AND/OR PROPERTY DAMAGE. Owner must ensure that all players know and follow these rules for safe operation of the unit. !Do not dunk on this unit Do not hang from any part of the unit, including the backboard, rim, or net. Keep organic material away from pole base. [. . . ] Be sure the arrows on the Slider Clamp point up the tube. Use carriage bolt (#25), two Slider Films (#28), and nylock nut (#7) through inside holes. Tighten only until end of bolt contacts plastic in nut. (The tightness of this nut affects the force needed to adjust the goal, and also the holding force of the clamp knob when tightened). Assemble bent end of Pull Tube (#19) to Slider Clamp (#27) with carriage bolt (#29), metal spacer (#26), flat washer (#8), and knob (#24). Make sure the Pull Tube is between Slider Films and the curved end is curving toward pole as shown in Figure 5. The pull tube needs to be held up until it is connected to the lower board arms to prevent it from scratching the slider tube. Hold at an angle as shown. 9. Figure 5 4 10. Attach the Lower Board Arms (#4) to the upper pole section as follows (refer to figure 6): IMPORTANT!The hole in the Lower Board Arm (#4) is not centered - one end of the Board Arm is longer than the other. The longer end of both Lower Board Arms should face the rear of the pole (the side with the slider bar attached to it). The dimple in the Board Arm should be against the pole. Use a 7-1/2" hex bolt (#16) and flat washer (#13), through the lower board arm, spacer (#35), nylon washer (#9), and stabilizer bracket (#34) and then through the middle hole in the upper pole section. Push the bolt all the way through the pole section and attach another stabilizer bracket (#34), nylon washer (#9), spacer (#35), and the other lower board arm (#4), and secure with a flat washer (#13) and hex nut (#14). Attach pull tube to lower board arms as shown in Figure 7. Use a 6" hex bolt (#17), six flat washers (#8), two spacers (#18), and a hex nut (#7). Tighten the hex nut (#7) just until it touches the washer and there is no loose space between any parts. At this time, go back and tighten hex nut (#14) from step 10 snugly, but do not overtighten. NOTE: Do not overtighten hex nuts in steps 11 and 12. the Lower Board Arms must be able to pivot freely. Figure 7 13. Next, attach a board bracket (#10) to one of the lower board arms. Make sure to align the hole patterns exactly as shown in Figure 8. [. . . ] Be sure concrete settles completely around pole and that tube stays in center of hole. Slope concrete away from pole for drainage. Straighten pole with a level (check from all sides). (See Figure 12) NOTE: Straighten pole by checking the top tube #1, not the middle or the bottom tubes. [. . . ]