User manual ESCALADE SPORTS 2L-6545-01

[. . . ] NOTE: Be sure brace on leg assembly #10 is against table. Tighten these locknuts snug but DO NOT OVERTIGHTEN THEM. Put caps #21 on bottom end of leg assembly #10. Attach upright assembly #11 to remaining brackets #6 on the bottom of the first top half #1. [. . . ] NOTE: If you have trouble inserting bolts #27 through name panels #8, slightly loosen bolts #26 (that you used in the previous section to attach name panels #8). ATTACHING CASTERS 11. Put caps #15 into ends of caster 11. Attach one non-locking caster #13 and one locking caster #14 to each caster beam #12 with push nuts #17. Attach caster beams to upright assemblies #11 with bolts #25, washers #23, and spacer bushings #19. NOTE: Spacers bushings #19 slide INSIDE caster beams #12 to keep beams from crushing. NOTE: Casters should always be locked unless moving table. 5 5. SETTING TABLE UPRIGHT CAUTION At least two adults are needed to complete the following steps. Be sure top halves are locked in safety latches!Be sure that both locking casters are locked!You must use a 7" stack of magazines (or similar block) to protect the casters when lifting table upright! 15. Before lifting table, be sure both top halves are locked in safety latches!Put a 7 inch stack of magazines, wood, etc. under caster beam nearest the floor to protect casters. With the help of one other adult, brace lower caster beam with your foot and lift table upright. Once upright, release safety latch and lower table top halves. (See Detail M and OPERATING INSTRUCTIONS on next page). MAKING FINAL ADJUSTMENTS If your gap between table halves is greater tahn 5/16" or uneven adjust it as follows. Loosen the six bolts shown below and adjust table so that the space between the two table top halves measures 5/16 of an inch. Check over entire assembly to be sure all nuts and bolts are secure. Remember, do not overtighten bolts at joints that move. 6 OPERATING INSTRUCTIONS CAUTION !"ALWAYS !" ALWAYS LOCK TABLE TOP HALVES IN SAFETY LATCHES WHEN STORING, MOVING, OR USING TABLE IN ITS PLAYBACK POSITION!ALWAYS LOCK CASTERS, EXCEPT WHEN MOVING TABLE!DO NOT SIT, STAND, WALK OR JUMP ON THIS TABLE! To open table: 1. [. . . ] To prevent damage to your table's playing surface DO NOT use any chemicals, abrasive, or cleaning products on your table's playing surface. Maintenance for your table: Be sure to oil all moving parts of your table, including pivot points. This will insure the safety and ease of use of your table. LIMITED 1 YEAR WARRANTY Manufacturer warrants to the original retail purchaser, this product to be free from defects in material and workmanship for a period of one (1) year from the date of purchase. Should this product become defective due to material or workmanship within the warranty period, contact our Customer Service Department. [. . . ]