User manual ESCALADE SPORTS 2L-6546-01

[. . . ] T8283 TOLL FREE 1-866-873-3528 (THIS IS A CONSUMER ONLY NUMBER) Please have this Owner's Manual with you when you call. Or write us at: CUSTOMER SERVICE DEPT. , P. O. Box 889, Evansville, IN 47706 Fax Number: (812) 467-1399. Please provide model number and/or part number (not just the key number) of the product and/or part when you call or write. These numbers can be found on the product, packaging, and/or in this Owner's Manual. Escalade Sports is a licensee of Spalding. [. . . ] By following these simple maintenance steps you will add to the life of your new table. The top (playing surface) of your table is of a particle board construction. Like all products made of wood, it can be affected by atmospheric conditions, meaning both temperature and humidity. This may cause a slight sag or distortion as top expands or contracts. This is normal and should not cause concern as it does not detract from the play or utility value of the table. To help minimize this problem, store table in folded up position in a dry area when not in use. STORAGE OF YOUR TABLE This table must be stored indoors to prevent damage to the playing surface. Dampness and extreme temperature changes can cause the wood to warp, swell, crack, or blister. When your table is not in use, it should be folded up in a dry area. CLEANING YOUR TABLE To clean your table use a soft damp NOT WET cloth only. To prevent damage to your table's playing surface DO NOT use any chemicals, abrasive, or cleaning products on your table's playing surface. IMPORTANT: Periodically, lubricate all moving parts, including pivot points, to assure smooth opening and closing. A light lubricant such as WD-40 is recommended. © 1999 Escalade Sports 1 TABLE TENNIS WARRANTY CENTER, P. O. BOX 889, EVANSVILLE, IN 47706-889 2L-6546-01 READ AND FOLLOW ALL ASSEMBLY, OPERATING, AND SAFETY INSTRUCTIONS CAREFULLY. AT LEAST THREE (3) ADULTS ARE NEEDED TO PUT THIS TABLE TOGETHER! 1. Position caster rails (#1) on the floor as shown approximately 30 inches apart. Figure 1 PIVOT TUBES MUST FACE INWARD AND POINT STRAIGHT UP AS SHOWN! Figure 2 AT LEAST THREE (3) ADULTS ARE NEEDED TO COMPLETE THE REST OF THIS ASSEMBLY!WHEN ASSEMBLING TOPS TO BASE, HANDLE TOP ASSEMBLIES BY GRASPING ONLY THE TOPS THEMSELVES. DO NOT GRASP METAL LEGS, H-SUPPORT, LINKAGE, OR HINGES. THESE PARTS CAN MOVE AND COULD PINCH FINGERS OR HANDS CAUSING SERIOUS INJURY!ASSEMBLE AS SHOWN WITH LEGS FULLY CLOSED AND TOPS IN A VERTICAL POSITION. TABLE TOPS ARE HEAVY - DO NOT ATTEMPT TO ASSEMBLE ALONE! 2. Have two adults hold the table top (#5) upright, while a third adult attaches ends of "H"-support tube with top of pivot tubes on caster rails (#1). [. . . ] Do not leave table partially opened at midway position. Lift table half to midpoint until the safety clips are engaged. Raise other table half in the same manner. Figure 5 Figure 3 3. Open other table half as in step 1 and 2. [. . . ]