User manual ESCALADE SPORTS 2L-6548-00

[. . . ] This warranty is also void if product is in any way abused, damaged, or modified from its original state, or if used for other than residential use. This warranty gives you specific legal rights, and you may have other rights which vary from state to state. 2L-6548-00 TOOLS NEEDED FOR ASSEMBLY CAUTION Tools Needed: !! AT LEAST TWO ADULTS ARE NEEDED TO COMPLETE THE ASSEMBLY!DO NOT LEAVE TABLE UNATTENDED UNTIL ASSEMBLY IS COMPLETE! ! [. . . ] Make sure legs #25 and #26 are open and the leg hinges are locked. With one person on each side of this table half, lift it and set it on legs. (See figure 5) While holding table half near net end, pull the frame under this table half until hole in "U" upright #8 is aligned with the lower middle hole in the leg mounting bracket #40 Secure table half to leg mounting brackets #40 using bolts #12, spacer #30, and locknut #13. Make sure that spacer #30 is between "U" upright #8 and leg mounting bracket #40. (See figure 5) FIGURE 5 Do not attempt to raise this half until other half top is attached and you have read and understand operating instructions FIGURE 6 11. Install linkages #22 as shown with linkage on the outside of "U" upright #8 and on the inside of the legs #25 and #26. Secure linkage #22 to legs #25 and #26 with one screw #24, one spacer #23 (between the linkage and the leg), one locknut #20 and one thread protector #43. Attach linkage #22 to "U" upright #8 with one bolt #21, one spacer #23 (between the linkage and the leg), one locknut #20. Tubes MUST be free to pivot. 4 DO NOT FOLD TABLE HALVES UP IN THE STORAGE POSITION UNTIL BOTH TABLE HALVES ARE INSTALLED AND ALL OPERATING INSTRUCTIONS ARE UNDERSTOOD. 12. Make sure legs #25 and #26 are open and the leg hinges are locked. With one person on each side of this table half, lift it and set it on legs. (See figure 7) While holding table half near net end, pull the frame under this table half until hole in "U" upright #8 is aligned with middle hole in the leg mounting bracket #40 Secure table half to base frame to leg mounting brackets #40 using bolts #12, spacer #30, and locknut #13. Make sure that spacer #30 is between "U" upright #8 and leg mounting bracket #40. 13. Install linkages #22 as shown with linkage on the outside of "U" upright #8 and on the inside of the legs #25 and #26. Secure linkage #22 to legs #25 and #26 with one screw #24, one spacer #23 (between the linkage and the leg), one locknut #20. Attach linkage #22 to "U" upright #8 with one bolt #21, one spacer #23 (between the linkage and the leg), one locknut #20. Tubes MUST be free to pivot. FIGURE 7 5 ATTACHING NET AND BRACKET g s il 14. Attach the four corner protectors (#27) to rails using tree plugs (#31). Simply push the plugs through the protector and into the rail until snug. See Figure 8. FIGURE 8 FIGURE 9 15. Secure net posts to center of table and slide net down over posts. See Figure 9. CARE AND MAINTENANCE You have purchased a quality product that will give you years of enjoyment. [. . . ] With both hands on the table half, center yourself along the table half and lower the table half to the floor. Repeat for the other table half. TO CLOSE: 1. Unlock hinges from both legs (see figure 9). Lift table half upward and inward to vertical position. [. . . ]