User manual ESCALADE SPORTS 2L-6551-00

[. . . ] OWNER'S MANUAL Table Tennis Table Patent Pending See separate sheet for product part numbers. Be sure to write your model number and serial number here for future reference. You can find these numbers printed on the bottom of the table. MODEL # T8233 SERIAL # CAUTION: READ ASSEMBLY, OPERATING AND SAFETY INSTRUCTIONS CAREFULLY!AT LEAST TWO ADULTS ARE NEEDED TO PUT THIS TABLE TOGETHER! Thank you for buying our product. [. . . ] Be sure to place it in a location where it won't be disturbed or damaged. If setting on its side, be sure to place the bottom edge no less than 12 inches away form the wall. Also be sure to place carpet or pieces of the shipping carton down to protect table top edges. If floor is not carpeted, brace table top half with a heavy object to keep it from sliding. Figure 6 16. Repeat steps 1 thru 10 on second table half. Gently tap caster sockets #12 into U-support #7 on second table half until flange on sockets touches the edge of the tube. DO NOT HIT CASTER SOCKETS TOO HARD WITH A HAMMER. Insert casters #11 into caster sockets #12 on second table half. Attach linkages #4 to the OUTSIDE of U-support #7 on second table half. NOTE: Tighten locknuts #15 finger tight only. They will be removed when the two table top halves are connected. G Figure 7 CAUTION: AT LEAST TWO ADULTS ARE NEEDED TO COMPLETE THE REMAINDER OF THE ASSEMBLY! 4 H Figure 8 20. Make sure the legs on the first table top half (the half with the U-braces #5) are open. With one person on each side of the table, lift and set table half on its legs. Place table against a wall as shown above to help stabilize table top half while second half is being attached. Be sure there is enough room to connect second half. CAUTION: BE SURE THE FIRST TABLE HALF YOU ASSEMBLED (WITH U-BRACES #5 ATTACHED) IS STABLE AND AGAINST A WALL. DO NOT LEAVE TABLE HALF STANDING UNATTENDED. 21. Place two hex bolts #18 and two locknuts #16 on floor next to caster wheels (on both sides of the table half) so they will be handy for the next step. With a person on both sides of the second table half, slide the second table half against the first table half. Align holes in U-braces #5 (on first table half) with holes in U-supports (on second table half). Secure these parts with the two hex bolts #18 and locknuts #16 you placed on the floor earlier. NOTE: DO NOT TIGHTEN LOCKNUTS UNTIL AFTER STEP #23. Figure 9 I 23. Remove locknuts #15 from screws #14 on second table half where U-support #7 and linkages #4 join. [. . . ] Like all products made of wood, it can be affected by atmospheric changes in both temperature and humidity. This may cause a slight sag or distortion as the top expands or contracts. This is normal and should not cause concern as it does not detract from the play or utility value of the table. After assembly of the table, you can minimize the effects of temperature and humidity changes by storing the table in the folded up position in a dry area when table is not in use. [. . . ]