User manual ESCALADE SPORTS 2L-6552-00

[. . . ] DROP POCKET HOME POOL TABLE IF YOU PURCHASED A BALL RETURN KIT WITH YOUR TABLE. USE THE INSTRUCTIONS IN THAT KIT TO ASSEMBLE YOUR TABLE. MODEL NOS. P1073 Thank you for buying our product. We try hard to insure that our products are of high quality and free of problems, such as manufacturing defects or missing parts. However, if you have any problems with your new product, please DO NOT RETURN IT TO THE STORE! [. . . ] NOTE: Be sure there are no gaps between center section #8 and slats. However do not tighten screws so much that center section begins to crush or crack. Place end sections #7 back on slats and secure using screws #38 (five screws per end section). NOTE: Be sure there are no gaps between end sections #7 and slats. Run your finger across the two seams between center section #8 and end sections #7 to check for any uneven areas. You should not need shims to even up the table top sections #7 and #8, so if the sections do not align, first try loosening screws and brush out underneath to remove chips etc. . Then check under table to make sure there are no gaps between the table top sections and the slats. However, do not tighten screws so much that the sections begin to crush or crack. Top edges of seams must be precisely level and even with one another. If you need to use shims, read the shimming instructions on the following page. 20. SHIMMING INSTRUCTIONS IF REQUIRED General Rules !Accomplish the leveling of the playing surface with as few shims as possible. Do not tap with a hammer or tighten screws unreasonably tight. You will not be able to compress the playing surface. You must shim up the playing surface to level. Shims are meant only to raise the low places at the seams and ends. USE A STRAIGHT EDGE TO CHECK THAT THESE AREAS ARE FLAT. Apply grout again if you find low places at countersunk holes or seams. 32. DO NOT SMOKE WHILE WORKING WITH CONTACT CEMENT!READ LABEL ON CEMENT CONTAINER CAREFULLY! Figure 13 Applying the cloth 34. Make sure slate/slatron is dry and free of dust. NOTE: Before spraying adhesive, cut a portion of the shipping carton to use as a shield to prevent cement overspray. Placeclothoverslate/slatronwithequaloverhangonallsides. NOTE:Clothmay seemsmallbutitwillstretchagreatdeal. Fold cloth away from end to expose slate/slatron for your first glue application. [. . . ] The middle hole for corner posts #45 has not been predrilled. Make a starter hole using a small finishing nail or an awl, tapping lightly with a hammer. This hole does not need to be very deep. Do not use a power screwdriver on these screws because screwdriver may slip off the screw 46 and scratch the finish on the 36 corner posts. 16 63. [. . . ]