User manual ESCALADE SPORTS 2L-6568-00

[. . . ] Rotate U-support #7 until you see the screw hole in the slot of U-clip #6 (See Figure 1, Detail). Slide U-support #7 side to side if necessary. NOTE: Screw hole may be in either U-clip. If you don't see hole in slot of one Uclip, look for it in the other U-clip. [. . . ] They will be removed when two table halves are connected. Make sure legs on the table half with the U-braces #5 (the first half you assembled) are open. With one person on each side of table, lift and set table half on its legs. Place table against a wall as shown below to help stabilize table half while second half is being attached. Be sure there is enough room to connect second half. Place two hex bolts #18 and locknuts #16 on floor next to caster wheels (both sides of table half) so they will be handy for the next step. With a person on both sides of second table half (the half without Ubraces #5), slide second table half against first table half. Align holes in U-braces #5 with holes in U-support #7. Secure with hex bolts #18 and locknuts #16. Do not tighten nuts until after step #17. Remove locknuts #15 from screws #14 on second table half where U-support #7 and linkages #4 join. Slide braces #9 on screws #14 and replace locknuts #15. Tighten locknuts snug but do not overtighten locknuts. Go back and tighten locknuts #16 from step 16. Attach a safety latch #8 to brace tube #9 as shown above, making sure the flange on the safety latch extends over brace INSTALL SAFETY LATCHES #8 AS tube #9. Secure safety latches #8 to brace #9 SHOWN ABOVE FOR PROPER USE with screws #10 and locknuts #15. opposite brace tube. CAUTION OPENING AND CLOSING INSTRUCTIONS READ OPERATING INSTRUCTIONS CAREFULLY BEFORE OPERATING TABLE!TABLE IS TO BE OPENED OR CLOSED BY ADULTS ONLY!FAILURE TO COMPLY WITH OPENING AND CLOSING INSTRUCTIONS COULD RESULT IN PERSONAL INJURY OR PROPERTY DAMAGE. OPEN: Stand behind the table near the safety latch. Hold table half with one hand and pivot safety latch enough to allow the edge of the table half to pass over it. While keeping an eye on the safety latch, pivot table half until it moves past the safety latch. Once edge of table has passed over safety latch, stop pivoting table half. [. . . ] To help minimize this problem, store table in folded up position in a dry area when not in use. STORAGE OF YOUR TABLE This table must be stored indoors to prevent damage to the playing surface. Dampness and extreme temperature changes can cause the wood to warp, swell, crack, or blister. When your table is not in use, it should be folded up in a dry area. CLEANING YOUR TABLE To clean your table use a soft damp NOT WET cloth only. To prevent damage to your table's playing surface DO NOT use any chemicals, abrasive, or cleaning products on your table's playing surface. [. . . ]