User manual ESCALADE SPORTS 2L-6599-02

[. . . ] Insert casters #11 into caster sockets #12. Figure 1 2. 3. Figure 2 Attach two Upright Tube Assemblies to both Name Plates #5, as shown in Figure 2, using four bolts #9 and four nuts #15. Figure 3 4. Connect the two Name Plate Assemblies to the Bottom Board #28, as shown in Figure 3, using four bolts #9 and four nuts #15. Install a safety latch #8 into the right-hand hole on each name panel as shown in Figure 3. Use one screw #10 one washer #17 and one hex nut #16. NOTE: Flange on safety latch must extend over top of name panel as shown in Figure 3. [. . . ] WHEN ASSEMBLING TOPS TO BASE, HANDLE TOP ASSEMBLIES BY GRASPING ONLY THE TOPS THEMSELVES. DO NOT GRASP METAL LEGS, U-SUPPORT, LINKAGE, OR HINGES. THESE PARTS CAN MOVE AND COULD PINCH FINGERS OR HANDS CAUSING SERIOUS INJURY!ASSEMBLE AS SHOWN WITH LEGS FULLY CLOSED AND TOPS IN A VERTICAL POSITION. TABLE TOPS ARE HEAVY - DO NOT ATTEMPT TO ASSEMBLE ALONE!With two adults, attach table top (#1) to table base, as shown in Figure 7. With at least one adult on each side of table top, lift top and align ends of "U"-support tube with top of upright tubes. With two adults, put other table top onto other pivot tubes following instructions in step 2. DO NOT OPEN THE TABLE TO PLAYING POSITION UNTIL BOTH TOPS ARE INSTALLED!IT COULD BE KNOCKED OVER CAUSING SERIOUS BODILY INJURY OR PROPERTY DAMAGE. 3 MELLO YELLO OPENING AND CLOSING INSTRUCTIONS READ OPERATING INSTRUCTIONS CAREFULLY BEFORE OPERATING TABLE!TABLE IS TO BE OPENED OR CLOSED BY ADULTS ONLY!FAILURE TO COMPLY WITH OPENING AND CLOSING INSTRUCTIONS COULD RESULT IN PERSONAL INJURY OR PROPERTY DAMAGE. TO 1. 3. OPEN: Stand behind the table near the safety latch. Pull legs out slightly from bottom of table. Hold table half with one hand and pivot safety latch enough to allow the edge of the table half to pass over it. While keeping an eye on the safety latch, pivot table half until it moves past the safety latch. Once edge of table has passed over safety latch, stop pivoting table half. With both hands on the table half, center yourself along the table half and lower the table half to the floor. Repeat for the other table half. TO CLOSE: 1. Lift table half upward and inward to vertical position. Check to be sure that table half is locked in the safety latch. Repeat for the other table half. 4 CARE AND MAINTENANCE You have purchased a quality product that will give you years of enjoyment. [. . . ] Set the table in its PLAYING POSITION and move table several inches in different directions to find the best location for the table. If the floor is extremely unlevel, table may not play or operate properly. If table is high in the center, shim up under the outer U-legs. LIMITED WARRANTY Manufacturer warrants to the original retail purchaser, this product to be free from defects in material and workmanship for a period of ninety (90) days from the date of purchase. Should this product become defective due to material or workmanship within the warranty period, contact our Customer Service Department for repair or replacement at our option. [. . . ]