User manual ESCALADE SPORTS 2L-6604-02

[. . . ] This warranty is also void if product is in any way abused, damaged, or modified from its original state, or if used for other than residential use. This warranty gives you specific legal rights, and you may have other rights which vary from state to state. WARRANTY Actual product may differ slightly from that shown in illustrations. CAUTION THIS IS A GAME TABLE. DO NOT SIT, STAND, LEAN, WALK OR JUMP ON TABLE!FAILURE TO COMPLY WITH THIS CAUTION COULD RESULT IN PERSONAL INJURY AND/OR PROPERTY DAMAGE! [. . . ] When your table is not in use, it should be folded up in a dry area. CLEANING YOUR TABLE To clean your table use a soft damp NOT WET cloth only. To prevent damage to your table's playing surface DO NOT use any chemicals, abrasive, or cleaning products on your table's playing surface. IMPORTANT: Periodically, lubricate all moving parts, including pivot points, to assure smooth opening and closing. A light lubricant such as WD-40 is recommended. © 2000 Escalade Sports 1 TABLE TENNIS WARRANTY CENTER, P. O. BOX 889, EVANSVILLE, IN 47706-889 2L-6604-02 READ AND FOLLOW ALL ASSEMBLY, OPERATING, AND SAFETY INSTRUCTIONS CAREFULLY. AT LEAST TWO (2) ADULTS ARE NEEDED TO PUT THIS TABLE TOGETHER! 1. Attach wood bottom board (#2) to caster rails (#1) as shown in Figure 1. Turn caster rail as shown with pivot tubes toward inside, and attach board (#2) with four carriage bolts (#3) and four wing nuts (#4). Tighten wing nuts securely. Figure 1 PIVOT TUBES MUST FACE INWARD AND POINT STRAIGHT UP AS SHOWN! AT LEAST TWO (2) ADULTS ARE NEEDED TO COMPLETE THE REST OF THIS ASSEMBLY! Figure 2 2. With another adult holding table top (#5) upright, attach ends of "U"-support tube with top of pivot tubes on caster rails (#1). Repeat this process for the other caster rail. Then slide second table top down over remaining two pivot tubes, making sure the playing surface of the second top faces the playing surface of the first. Snap Paddle Box Bottoms (#16) onto Paddle Box Tops on bottom of table tops (#5). 3. 4. DO NOT OPEN THE TABLE TO PLAYING POSITION UNTIL BOTH TOPS ARE INSTALLED!IT COULD BE KNOCKED OVER CAUSING SERIOUS BODILY INJURY OR PROPERTY DAMAGE. 2 NET ASSEMBLY Net System Description 1. Net Post Assembly Attach plastic net post as shown with washer and knob. Note: there is a left and right net post assembly (See Net System Description). Post assembly should rest flat against nut plate. Slide the net sleeve over the vertical post while the net post assembly is folded in toward the side of the table top. Fold the net post assembly out against the net post stop into the post and secure bead chain in catch. 2. Adjustments A - Adjust overall net tension by slightly loosening the knob and moving net post assembly. [. . . ] Continue to pull until disengaged from safety clips and legs rest on the floor. Do not leave table partially opened at midway position. See Figure 3. TO CLOSE: Caution: To prevent damage to the net system and/or table top, the post assembly must be pivoted toward side of table before lifting table tops to storage position. Lift table half to midpoint until the safety clips are engaged. [. . . ]