User manual ESCALADE SPORTS 2L-6608-02

[. . . ] DROP POCKET HOME POOL TABLE Thank you for buying our product. We try hard to insure that our products are of high quality and free of problems, such as manufacturing defects or missing parts. However, if you have any problems with your new product, please DO NOT RETURN IT TO THE STORE!Call Escalade Sports at: TOLL FREE 1-800-426-1421 (THIS IS A CONSUMER ONLY NUMBER) FAX 812-467-1399 Or write us at: CUSTOMER SERVICE DEPARTMENT P. O. [. . . ] However do not tighten screws so much that center section begins to crush or crack. Be sure they are square, in line and butted up tight against center slate #8. 17. Place end sections #7 back on slats and secure using screws #38 (five screws per end section). NOTE: Be sure there are no gaps between end sections #7 and slats. Run your finger across the two seams between center section #8 and end sections #7 to check for any uneven areas. You should not need shims to even up the table top sections #7 and #8, so if the sections do not align, first try loosening screws and brush out underneath to remove chips etc. . Then check under table to make sure there are no gaps between the table top sections and the slats. However, do not tighten screws so much that the sections begin to crush or crack. Top edges of seams must be precisely level and even with one another. If you need to use shims, read the shimming instructions on the following page. 6 15. SHIMMING INSTRUCTIONS IF REQUIRED General Rules 18 Accomplish the leveling of the playing surface with as few shims as possible. 19 Do not tap with a hammer or tighten screws unreasonably tight. You will not be able to compress the playing surface. You must shim up the playing surface to level. Shims are meant only to raise the low places at the seams and ends. Very short and low places should be filled with grout. Most leveling can be accomplished by working with the frame. 20 If using power tools be sure to use only enough torque to reasonably tighten screws. 21 Seams can best be checked by passing your finger over the seam and feeling if it is flush. 22 All screws must be tightened after shimming. Figure 10 Top of playing surface must be flush at seams! shim STEP BY STEP SHIMMING 23. Be sure table is set in its final location. Table must be as level as possible before shimming. [. . . ] Make a starter hole using a small finishing nail or an awl, tapping lightly with a hammer. This hole does not need to be very deep. Do not use a power screwdriver on these screws because screwdriver may slip off the screw and scratch the finish on the corner posts. Place the sight plugs #46 into the rails by pressing them firmly into the predrilled holes as shown in figure 20. [. . . ]