User manual ESCALADE SPORTS 2L-6621-02

[. . . ] OWNER'S MANUAL MODEL NOS. AZTEC 8FT. SLATRON HOME POOL TABLE WITH DROP POCKETS !ASSEMBLY !OPERATION !SERVICE !INSTALLATION !REPLACEMENT PARTS !WARRANTY For aid in identifying the different hardware used in this assembly, use the hardware identifier below. Each number refers to the numbers shown in the illustrations within this manual. For more specific information about the hardware, see the replacement parts list in the back of this manual. [. . . ] Dry soap on screw threads move chips etc. . Then check under table to make sure will make this job easier. CAUTION: When driving there are no gaps between the table top sections and the screws through slatron sections, hold slatron down tight slats. However, do not against the slats so they don't ride up on the screws. tighten screws so much that the sections begin to crush NOTE: Be sure there are no gaps between center or crack. Top edges of seams must be precisely level and section #10 and slats. If gaps exist, tighten screws even with one another. If you need to use shims, read the Page more. However do not tighten screws so much that shimming instructions on the following page. 6 center section begins to crush or crack. SHIMMING INSTRUCTIONS General Rules !Accomplish the leveling of slatron with as few shims as possible. Do not tap with a hammer or tighten screws unreasonable tight. You will not be able to compress the slatron. Shims #38 are meant only to raise the low places at the seams and ends. Very short and low places should be grouted. Most leveling can be accomplished by working with the frame. If power tools are used, be sure only enough torque is used to do the job. Seams can best be checked by passing your finger over the seam joint and feeling if it is flush. All screws must be tightened after shimming. No two sets of slatron are exactly alike. Some sets require more, or less, shimming than others. Figure 9 19. STEP BY STEP SHIMMING PROCEDURE A) Be sure table is set in its final location. [. . . ] (See Figure 20) Slide corner posts #8 onto the ends of the aprons as shown in figure 20 and tighten apron mounting screws tight again. This clamps the corner posts tightly in place between the aprons and the rails. Page 10 44. Before attaching the drop pockets to the rails you will need to trim two of them to fit into the side pockets. (See figure 23) Insert the corner and side drop pockets (the two that you have trimmed) into the drop pocket openings on the table. [. . . ]