User manual ESCALADE SPORTS 2L-6638

[. . . ] OWNER'S MANUAL OWNER'S MANUAL DROP POCKET 8 FT. SLATE HOME POOL TABLE Thank you for buying our product. We try hard to insure that our products are of high quality and free of problems, such as manufacturing defects or missing parts. However, if you have any problems with your new product, please call us at: SERVICE Or write us at: CUSTOMER SERVICE DEPARTMENT P. O. [. . . ] THE HELP OF ANOTHER ADULT! Figure 11 11. You can tell the top side of the slate by the beveled edge of the pocket openings and the countersunk mounting holes. The beveled edges and the countersunk holes must face up. (See figure 11) A) Place center section #10 on the two long slats #16. If edges do not align exactly, center slate as much as you can. The long slats are 50 inches long, so there should be 1/2 inch of slate over hanging the ends of the slats, use a tape measure to make sure there is an 1/2'' over hang. REMEMBER: Be sure countersunk holes in the slate face up! B) Secure center section #10 to long slats #16 with screws #39 into countersunk holes. NOTE: It is important that the edges of the three pieces of slate are flush and square. Be sure they are square, in line and butted up tight against center slate #10. Secure end slate pieces #9 to slats using screws #39 into countersunk holes. NOTE: If necessary, shim underneath slate where they join together to obtain a smooth, even surface. Slate shims are provided in the slate bed kit. EDGES OF SLATE MUST BE EVEN WITH ONE ANOTHER! 8 SHIMMING INSTRUCTIONS FOR SLATE General Rules !Accomplish the leveling of the playing surface with as few shims as possible. Do not tap with a hammer or tighten screws unreasonably tight. You will not be able to compress the playing surface. You must shim up the playing surface to level. Shims are meant only to raise the low places at the seams and ends. Very short and low places should be filled with wood putty. Most leveling can be accomplished by working with the frame. If using power tools be sure to use only enough torque to reasonably tighten screws. Seams can best be checked by passing your finger over the seam and feeling if it is flush. All screws must be tightened after shimming. 13. [. . . ] Connect the rail assemblies to the side pockets. (See figure 18) Snug rails against pocket edges before tightening bolts #20. Figure 18 33. The rail cushion nose to nose dimension should measure 44 inches by 88 inches or as close as possible. (See figure 19) NOTE: Look along the nose rubber of the side rails to be sure they align. Figure 19 11 Figure 20 NOTE: Find the parts needed to complete this step and position them on the floor around the table. [. . . ]