User manual ESCALADE SPORTS 2L-6640-00

[. . . ] Insert casters #11 into caster sockets #12. Figure 1 2. 3. Figure 2 Attach two Upright Tube Assemblies to both Name Plates #5, as shown in Figure 2, using four bolts #9 and four nuts #15. CAUTION: INSTALL SAFETY LATCHES #8 AS SHOWN ABOVE FOR PROPER USE OF TABLE!DO NOT OPERATE TABLE UNTIL SAFETY LATCHES ARE INSTALLED AND ASSEMBLY IS COMPLETE! Figure 3 4. Connect the two Name Plate Assemblies to the Bottom Board #28, as shown in Figure 3, using four bolts #9 and four nuts #15. Install a safety latch #8 into the right-hand hole on each name panel as shown in Figure 3. Use one screw #10 one washer #17 and one hex nut #16. [. . . ] With two adults, attach table top (#1) to table base, as shown in Figure 7. With at least one adult on each side of table top, lift top and align ends of "U"-support tube with top of upright tubes. With two adults, put other table top onto other pivot tubes following instructions in step 2. DO NOT OPEN THE TABLE TO PLAYING POSITION UNTIL BOTH TOPS ARE INSTALLED!IT COULD BE KNOCKED OVER CAUSING SERIOUS BODILY INJURY OR PROPERTY DAMAGE. 3 NET ASSEMBLY Net System Description 1. Net Post Assembly Attach plastic net post as shown with washer and knob. Note: there is a left and right net post assembly (See Net System Description). Post assembly should rest flat against nut plate. Slide the net sleeve over the vertical post while the net post assembly is folded in toward the side of the table top. Fold the net post assembly out against the net post stop into the post and secure bead chain in catch. 2. Adjustments A - Adjust overall net tension by slightly loosening the knob and moving net post assembly. Net post assembly should be kept square with the table by the net post stop (See Net System Description). B - Adjust tension of cord with bead chain on each side. Assure that chain is fully seated in catch. C - Position top of net to a regulation height of 6" from the table surface by firmly gripping the vertical net post within height adjustment slot. 3. Storage Caution: To prevent damage to the net system and/or table top, the post assembly must be pivoted toward side of table before lifting table tops to storage position. Loosen knob and pivot net post toward table side as far as it will go. Retighten Knob. 4 OPENING AND CLOSING INSTRUCTIONS READ OPERATING INSTRUCTIONS CAREFULLY BEFORE OPERATING TABLE!TABLE IS TO BE OPENED OR CLOSED BY ADULTS ONLY!FAILURE TO COMPLY WITH OPENING AND CLOSING INSTRUCTIONS COULD RESULT IN PERSONAL INJURY OR PROPERTY DAMAGE. TO OPEN: 1. Stand behind the table near the safety latch. Hold table half with one hand and pivot safety latch enough to allow the edge of the table half to pass over it. [. . . ] Set the table in its PLAYING POSITION and move table several inches in different directions to find the best location for the table. If the floor is extremely unlevel, table may not play or operate properly. If table is high in the center, shim up under the outer U-legs. LIMITED WARRANTY Manufacturer warrants to the original retail purchaser, this product to be free from defects in material and workmanship for a period of ninety (90) days from the date of purchase. Should this product become defective due to material or workmanship within the warranty period, contact our Customer Service Department for repair or replacement at our option. [. . . ]