User manual ESCALADE SPORTS 2L-6668-00

[. . . ] This warranty gives you specific legal rights, and you may have other rights which vary from state to state. Actual product may differ slightly from that shown in illustrations. CAUTION THIS IS A GAME TABLE. DO NOT SIT, STAND, LEAN, WALK OR JUMP ON TABLE!FAILURE TO COMPLY WITH THIS CAUTION COULD RESULT IN PERSONAL INJURY AND/OR PROPERTY DAMAGE! This table must be kept indoors to prevent damage to the playing surface. Dampness and extreme temperature changes which occur on patios, garages or similar areas can cause wood to warp, swell, crack, or blister. UNLEVEL FLOORS If table does not seem level, it is probably because floor is not level. [. . . ] To prevent damage to your table's playing surface DO NOT use any chemicals, abrasive, or cleaning products on your table's playing surface. IMPORTANT: Periodically, lubricate all moving parts, including pivot points, to assure smooth opening and closing. A light lubricant such as WD-40 is recommended. © 2001 Escalade Sports 1 TABLE TENNIS WARRANTY CENTER, P. O. BOX 889, EVANSVILLE, IN 47706-889 2L-6668-00 1. Locate one "R" pivot bracket (#7) and one "L" pivot bracket (#9). NOTE: Pivot brackets have an "R" or "L" stamped on the front of them to make them easy to identify. Attach "R" and "L" pivot brackets and pivot tubes (#8) to caster rail (#1), with the angles toward the ends of the caster rail (See Figure 1b), using one hex bolt (#22), two nylon washers (#32) and one locknut (#31). Do NOT overtighten bolts securing pivot tubes. Secure pivot brackets to caster rail with two hex bolts (#23) and locknuts (#31). Insert a caster wheel (#5) through the hole at each end of the caster rail, as shown in Figure 1a. Tap a palnut (#6) onto the shaft protruding through the top of the caster rail. 5. 2. Figure 1a Tap a square plug (#29) into each end of the caster rail. Repeat steps 1 through 4 for second caster rail. 3. Figure 1b 2 READ AND FOLLOW ALL ASSEMBLY, OPERATING, AND SAFETY INSTRUCTIONS CAREFULLY. AT LEAST TWO (2) ADULTS ARE NEEDED TO PUT THIS TABLE TOGETHER! 6. Attach wood bottom board (#2) to caster rails (#1) as shown in Figure 2. Turn caster rail as shown with pivot tubes toward inside, and attach board (#2) with four carriage bolts (#3) and four wing nuts (#4). Tighten wing nuts securely. Figure 2 Figure 3 PIVOT TUBES MUST FACE INWARD AND POINT STRAIGHT UP AS SHOWN! AT LEAST TWO (2) ADULTS ARE NEEDED TO COMPLETE THE REST OF THIS ASSEMBLY!WHEN ASSEMBLING TOPS TO BASE, HANDLE TOP ASSEMBLIES BY GRASPING ONLY THE TOPS THEMSELVES. DO NOT GRASP METAL LEGS, U-SUPPORT, LINKAGE, OR HINGES. THESE PARTS CAN MOVE AND COULD PINCH FINGERS OR HANDS CAUSING SERIOUS INJURY!ASSEMBLE AS SHOWN WITH LEGS FULLY CLOSED AND TOPS IN A VERTICAL POSITION. TABLE TOPS ARE HEAVY - DO NOT ATTEMPT TO ASSEMBLE ALONE! 7. Attach table top (#5) to table base that you just assembled, as shown in Figure 3. [. . . ] This will insure proper net tension. Figure 6 TO CLOSE: 1. Lift one table half to midpoint until the safety clips are engaged. Unlock leg hinges on this half and fold legs against top. Raise other table half in the same manner. Figure 4 3. [. . . ]