User manual ESCALADE SPORTS 2L-6708-00

[. . . ] These numbers can be found on the product, packaging, and/or in this Owner's Manual. Lower Limb Visit our website for additional information and possible solutions to your problems: MODEL A4284RBOX SHOOTING YOUR COMPOUND BOW www. escaladesports. com WARNING NOT A TOY FOR USE BY CHILDREN!Bow and arrows shipped in this set are matched. Do not use arrows in any other bow. DO NOT SHOOT YOUR BOW WITHOUT AN ARROW (DRY FIRE)!ALWAYS USE ARROWS PROPERLY SPINED FOR THIS BOW. [. . . ] If any damage is detected, bow or arrow must be destroyed! DRAW WEIGHT ADJUSTMENT This compound bow is factory pre-set at peak draw weight. LIMB DRAW WEIGHT ADJUSTMENT BOLT To change the draw weight. . . Turn the draw weight adjustment bolt clockwise to increase the draw weight and counter-clockwise to decrease the draw weight. When making draw weight adjustments, make sure to turn the draw weight adjustment bolts the same amount on both the upper and the lower limbs in order to keep your bow in tune. (See Figure A) THREADED INSERT ARROW REST LOCKNUT HANDLE v DO NOT ADJUST BOLTS OUT MORE THAN THREE (3) FULL REVOLUTIONS FROM THE COMPLETELY TIGHTENED POSITIONS. FIGURE A HANDLE ARROW REST Included with this bow is an adjustable arrow rest. (See Figure B1) Place the threaded post of the rest into the threaded insert in the handle. Rotate the rest clockwise 18 turns to align the rest with the center of the bow-string. (This may require turning the rest with pliers. Using light pressure, hold the rest on the top and bottom edges. ) Place the locknut on the threaded post of the rest which is exposed on the opposite side of the handle. Snug the locknut to the handle to hold the arrow rest in position. Figure B2 shows the arrow rest in proper location. Minor adjustments to center the arrow are made by loosening the locknut and rotating the rest a full turn in either direction, re-snug the locknut. NEVER SHOOT THE BOW WITH AN ARROW OFF OF THE ARROW REST. FIGURE B1 QUIVER ARROW LOCATION SIGHT FIGURE B2 SIGHT PLATE AND QUIVER INSTALLATION Install quiver and sight to bow (as shown in figure C) with two #10-24 x 3/4" pan head screws. NOTE: The quiver is mounted on top of the sight plate. FIGURE C SIGHT PIN ASSEMBLY AND ADJUSTMENT Loosen locknut shown above for adjustment. Move pin up or down in the slot to change height of arrow trajectory. Move pin by rotating threads clockwise or counterclockwise to change trajectory right and left. NOTE: Slot in sight plate to this side THE ARROW The arrow nock always has the groove positioned so that the index vane clears the bow in the best fashion. (See Figure D) FIGURE B3 STRING NOCKING THE ARROW Place the arrow nock groove on the string. Make sure the arrow nock groove is completely seated on the string. The arrow should be 90 degrees (right angle) to the string. FIGURE D INDEX VEIN ARM GUARD Put the arm guard on the arm with which you hold the bow. It should cover the inside of the lower arm to protect it from being slapped by the string when string is released. (Figure E) FINGER TAB The finger tab protects your fingers from rubbing by the bow string when string is released. (Figure F) FIGURE E To place finger tab on hand 1. Slip the finger tab over your second finger so that the tab is on the palm side of your hand with the small lobe up. Bend the tab so that the small lobe covers your index finger and the large lobe covers your middle two fingers. FIGURE F HOLDING THE STRING AND ARROW Hook the three fingers on the string at the first joint. [. . . ] Each compound bow is pre-set and 100% inspected at the factory before it is packed in the special protective shipping container. Your compound bow is warranted for 90 days from the date of purchase against defects in material and workmanship. The complete warranty is printed on front of this manual. Note that no party other than Escalade Sports is authorized to make warranty adjustments on your bow. [. . . ]