User manual ESCALADE SPORTS 2L-6740-00

[. . . ] DROP POCKET HOME POOL TABLE Questions, Concerns, Comments?Need Product Assistance? Escalade Sports, a diversified manufacturer of fine sporting goods equipment, is here to help you in any way possible to make your experience with this product a pleasurable one for you and your family. We always try hard to make sure that our products are manufactured free from defects in material and workmanship to provide a lifetime of family fun. If you find any problems with your new product such as missing parts, damaged parts, or incorrectly manufactured parts, Please Do Not Return This Product to the Store! Please contact our consumer affairs department at: MODEL NOS. [. . . ] Sections should be cause table top sections to be uneven. Place center section #10 back on slats and secure it to long slats #16 with six screws #39. Dry soap on screw threads will make this job easier. CAUTION: When driving screws through slatron sections, hold slatron down tight against the slats so they don't ride up on the screws. NOTE: Be sure there are no gaps between center section #10 and slats. However do not tighten screws so much that center section begins to crush or crack. You should not need shims to even up the table top sections #9 and #10, so if the sections do not align, first try loosening screws and brush out underneath to remove chips etc. . Then check under table to make sure there are no gaps between the table top sections and the slats. However, do not tighten screws so much that the sections begin to crush or crack. Top edges of seams must be precisely level and even with one another. If you need to use shims, read the shimming instructions on the following page. Page 7 SHIMMING INSTRUCTIONS General Rules + Accomplish the leveling of slatron with as few shims as possible. + Do not tighten screws unreasonable tight. Shims #38 are meant only to raise the low places at the seams and ends. Very short and low places should be grouted. Most leveling can be accomplished by working with the frame. + If power tools are used, be sure only enough torque is used to do the job. + Seams can best be checked by passing your finger over the seam joint and feeling if it is flush. + All screws must be tightened after shimming. + No two sets of slatron are exactly alike. Some sets require more, or less, shimming than others. Figure 11 20. STEP BY STEP SHIMMING PROCEDURE A) Be sure table is set in its final location. B) Table must be as level as possible before shimming. [. . . ] Punch pilot holes in rail using an awl (or 8d nail) and hammer. This will require the help of another person. (See Figure 21) NOTE: To help drive screws into rails, put a little dry soap on threads of screw. Slightly loosen the screws holding the aprons to the rails in the center of table. [. . . ]