User manual ESCALADE SPORTS 2L-6778-01

[. . . ] HOME POOL TABLE WITH DROP POCKETS + ASSEMBLY + OPERATION + SERVICE + INSTALLATION + REPLACEMENT PARTS + WARRANTY For aid in identifying the different hardware used in this assembly, use the hardware identifier below. Each number refers to the numbers shown in the illustrations within this manual. For more specific information about the hardware, see the replacement parts list on page 11. MODEL NOS. P2011 READ THESE INSTRUCTIONS CAREFULLY! 2L-6778-01 IMPORTANT!READ THIS MANUAL ALL THE WAY THROUGH BEFORE BEGINNING TO PUT YOUR POOL TABLE TOGETHER! [. . . ] Large differences in levelness must be corrected by raising or lowering frame with shim stock or playing cards. C) Tighten down all slatron mounting screws. D) Check with a carpenter's level to determine where slatron is low on ends, and use finger tips to locate uneven spots at the seams. Loosen screws at these points and see if slatron comes up to flush. If so, detach individual shims #26 from the sheet shipped with this table and place under these areas. (See Figure 8) E) Lay a straight edge across seams to be sure slatron pieces are flat in relation to each other. F) After top surface of slatron is flat and level, all screws must be snugged down in tight position. Check these screws before beginning grouting. GROUTING INSTRUCTIONS 15. Prepare Plaster of Paris, furnished with this table. Do not mix all the powder at first; save some in case you need to thicken your initial mixture. To mix: Empty 1/3 to 1/2 of grout into container, slowly add drops of water while stirring. Grout should be a thick paste when mixed that will not drip off putty knife. If you do get grout to thin, slowly add more powder. Using a putty knife, fill seam and the four countersunk holes in the center playfield area. (Only the four countersunk holes in the center of the table need to be filled since the other holes will be covered by the rails or are too small to matter. ) Do not use more plaster than you need. Page 18. Read the rest of this manual while you wait!Using a medium grit sandpaper and a sanding block, sand the plastered areas smooth and flat. RECHECK THESE AREAS TO MAKE SURE THEY ARE FLAT. Re-plaster if you still find low places at countersunk holes or seams. 6 DO NOT SMOKE WHILE WORKING WITH CONTACT CEMENT!READ LABEL ON CEMENT CONTAINER CAREFULLY! Figure 9 Applying the cloth 20. Make sure slatron is dry and free of dust. NOTE: Before spraying adhesive, cut a portion of the shipping carton to use as a shield to prevent cement overspray. [. . . ] Rails have pre-drilled starter holes on their underneath side. (See figure 14) Do not tighten screws tight yet. Follow the same procedure to attach end rails #4. NOTE: to help drive screws into rails, put a little dry soap on screws threads. [. . . ]