User manual ESCALADE SPORTS 2L-6786-00

[. . . ] B2 208 Goaliath II BASKETBALL SYSTEM MODEL NO. OWNER'S MANUAL 1. Read this manual carefully before starting assembly. Read each step completely before beginning each step. Some smaller parts may be shipped inside larger parts. [. . . ] Before putting any of the pole tubes together, mark bottom pole (#2) 6 inches from the top end. Align the upper pole (#3) with the bottom pole (#2) and slide them together. Stand tubes up on a block of wood and hit tubes on piece of wood until the bottom of the upper pole reaches the 6" mark on the middle pole. This is a friction-locking joint and requires no hardware. Figure 3 Attach Right Post Ear (#30) and Left Post Ear (#31) to holes near the bottom of Top Post (#3) using two hex bolts (#25) four washers (#18) and two lock nuts (#4). The angled edge of the Post Ears (#30 and #31) should be on bottom. Tighten bolts (#25) tight. 3. Figure 4 Slide Actuator Sleeve (#15) over Actuator (#16) and place Actuator Cap (#13) on top. Slide Pivot Tube (#14) in hole near the top of Actuator until equal amounts stick out on both sides of Actuator. NOTE: If necessary, use a hammer or rubber mallet to tap in Pivot Tube (#14). Lay Pole Assembly on its side on two padded saw horses. Slide tab on Actuator (#16) between Post Ears (#30 and #31) and secure using one bolt (#19), two washers (#20) and one lock nut (#4). Insert Pole Cap (#1) onto top of Top Pole (#3). Secure two stop spacers (#10) to pole, as shown in Figure 4, using one hex bolt (#22) and one lock nut (#4). 7. 5 Figure 5 8. Attach lower arms (#11) to Top Pole (#3), as shown in Figure 5, using a hex bolt (#22), two flatwashers (#18), two plastic washers (#5) and lock nut (#4). Note: make sure lettering is right side up. Do NOT tighten bolt (#22) at this time. Secure Actuator (#16) to Lower Arms (#11) using one bolt (#22), two flatwashers (#18), two plastic washers (#5) and one lock nut (#4). Tighten both bolts (#7) securing Lower Arm (#11). Note: Tighten bolts snug but, do not over tighten. Insert four Tube Plugs (#9) into open ends of Lower Arms (#11). It may be necessary to use a hammer or rubber mallet to tap them in. 9. Figure 6 11. Attach long leg of Upper Arms (#6) to Top Pole (#3), as shown in Figure 7, using a bolt (#7), two flatwashers (#18), two spacers (#8) and one lock nut (#4). Note: Tighten bolts snug but, do not over tighten. Insert four Tube Plugs (#9) into open ends of Upper Arms (#6). [. . . ] ­ RIM ­ HANGING ON THE RIM WILL VOID YOUR WARRANTY. Rims are not warranted for any defects other than workmanship. Torn back plates, damaged springs, bent rings, damaged eye bolts, and torn or distorted rim supports result from hanging on the rim and are not warranted. The goal should not be cranked over 10'. [. . . ]