User manual ESCALADE SPORTS 2L-7051-01

[. . . ] MODEL NO. B2 216W Goaliath BASKETBALL SYSTEM OWNER'S MANUAL 1. Read this manual carefully before starting assembly. Read each step completely before beginning each step. Some smaller parts may be shipped inside larger parts. [. . . ] Attach Upper Board Arms to upper mounting tubes on backboard using two bolts (#24), two plastic washers (#5), four washers (#18) and two lock nuts (#4). Snug is tight enough. 8 Figure 11 19. Remove protective backboard covering and mount Goal Assembly (#28) and Rim Pad (#27) to Backboard, as shown in Figure 11, using four bolts (#49), four washers (#26), and four locknuts (#4). Tighten fasteners finger tight, leave them loose enough to level rim. Place a level across rim assembly and adjust rim until it is level. Finish tightening the four nuts. NEVER USE RIM WITH COVERPLATE REMOVED! 21. Attach Rim Cover Plate (#32) using four screws (#33). Check all nuts and bolts and make sure everything is tightened properly. Do NOT over tighten pivot points, snug is tight enough. Use the Backboard Pads (#44) and (#45) as a template and mark the hole locations on the backboard frame. Drill 9/64" pilot holes into steel backboard frame. Do not drill through both sides of tube. Secure Backboard Pads (#44) and (#45), as shown, using screws (#66). Note: Tighten screws tight but, do not over tighten. Detail A Figure 12 26. Use a tape measure to measure from the top of the rim to the playing surface. Stick Height Decal (#17) to back of Actuator (#16) with the "7. 5" mark aligned with bottom of Actuator Sleeve (#15). Remove the screw at top of light that holds frame together. The door frame assembly will swing down to open. Using gloves or soft cloth insert one end of bulb into socket. Gently apply pressure to the bulb to one side and insert opposite end of bulb into other socket. Note: Do not touch halogen bulb with your hand as oil in your skin will cause damage to the bulb. You can reverse this procedure to remove the bulb. Figure 13 60 59 51 59 51 60 59 68 65 57 28. [. . . ] Shipping charges for replaced or warranted merchandise sent back to the customer from Escalade® Sports factory must be prepaid by the customer in advance. If not, the replacement shipment will be sent out collect. Escalade® Sports reserves the right to examine photographs or physical evidence of merchandise claimed to be defective, and to recover said merchandise, prior to authorization of warranty claims. A "Returned Goods Authorization" number may be required, please call for details prior to the return of any photographs or merchandise. [. . . ]