User manual ESCALADE SPORTS 2L-7073-01

[. . . ] Tools required for assembly: Phillips Screwdriver, Two 7/16 Wrenches, One 3/8 Wrench (an adjustable wrench may be substituted for the wrenches), Flat Blade Screw Driver Please Do Not Return This Product To The Store! Contact Escalade® Sports customer service department at: Phone: 1-866-873-3528 Toll ­ Free !E-mail: tabletennis@escaladesports. com Mailing Address (correspondence only): Escalade Sports PO Box 889 Evansville, IN 47706 Please visit our World Wide Web site at: www. escaladesports. com ON-LINE TROUBLE SHOOTING ON-LINE PARTS REQUESTS TECHNICAL ASSISTANCE FREQUENTLY ASKED QUESTIONS ADDITIONAL ESCALADE® SPORTS PRODUCT INFORMATION 2L-7073-01 Escalade® Sports products may be manufactured and/or licensed under the following patents. 6120397, 5816957, 5769744, 5119741, 4911085, 4717157, D460140, D420563 Additional patents may be pending. One or more of the listed patents and/or pending patents may cover specific product. 1. Insert one caster with brake #33 and one caster without brake #32 into caster sockets in each side panel assembly #35. [. . . ] WHEN ASSEMBLING TOPS TO BASE, HANDLE TOP ASSEMBLIES BY GRASPING ONLY THE TOPS THEMSELVES. DO NOT GRASP METAL LEGS, USUPPORT, LINKAGE, OR HINGES. THESE PARTS CAN MOVE AND COULD PINCH FINGERS OR HANDS CAUSING SERIOUS INJURY!ASSEMBLE AS SHOWN WITH LEGS FULLY CLOSED AND TOPS IN A VERTICAL POSITION. TABLE TOPS ARE HEAVY - DO NOT ATTEMPT TO ASSEMBLE ALONE!With two adults, attach table top #1 to table base, as shown in Figure 5. With at least one adult on each side of table top, lift top and align ends of "U"-support tube with top of upright tubes. With two adults, put other table top onto other pivot tubes following instructions in previous step. Attach corner caps #9 to outer corners of tops. Push two hole plugs #25 into holes in each apron. DO NOT OPEN THE TABLE TO PLAYING POSITION UNTIL BOTH TOPS ARE INSTALLED!IT COULD BE KNOCKED OVER CAUSING SERIOUS BODILY INJURY OR PROPERTY DAMAGE. 19. 20. 21. 3 NET ASSEMBLY Slide loop end of net over post 1. 2. Secure net posts #41 to center of table. Place net on net posts by first sliding loop end of net onto one net post, then, wrap velcro straps on the other end of net around other net post. NOTE: Net will be tight and may appear to be short. Over time as net stretches, adjust net to proper tension using velcro straps. Wrap velcro around net post 41 4 OPENING AND CLOSING INSTRUCTIONS READ OPERATING INSTRUCTIONS CAREFULLY BEFORE OPERATING TABLE!DO NOT CLIMB, SIT, STAND OR JUMP ON TABLE!TABLE CAUTION: IS TO BE OPENED OR CLOSED BY ADULTS ONLY!FAILURE TO COMPLY WITH OPENING AND CLOSING INSTRUCTIONS COULD RESULT IN PERSONAL INJURY OR PROPERTY DAMAGE. To Open: IMPORTANT!Two people are required to lower table half. Do NOT remove latches and do NOT make any of the latches inoperable. [. . . ] CLEANING YOUR TABLE To clean your table use a soft, damp (NOT WET) cloth only. To prevent damage to your table's playing surface, DO NOT USE ANY CHEMICALS, ABRASIVE OR CLEANING PRODUCTS on your table's playing surface. MAINTENANCE OF YOUR TABLE Be sure to oil all moving parts of your table including the pivot points. This will insure the safety and ease of use of your table. [. . . ]