User manual ESCALADE SPORTS G0120

[. . . ] Call us at: 1-800-426-1421 (THIS IS A CONSUMER ONLY NUMBER) FAX: 812-467-1399 OR WRITE TO: ESCALADE SPORTS CUSTOMER SERVICE DEPARTMENT P. O. BOX 889 EVANSVILLE, IN 47706 When contacting Escalade Sports please provide model number, serial number (if applicable), and part number if requesting a replacement part. These numbers can be found on the product, packaging, and in this Owner's Manual. 1 REQUIRED TOOLS PHILLIPS SCREWDRIVER STANDARD SCREWDRIVER ADJUSTABLE WRENCH OR STANDARD SOCKET SET 2 0120-C10 PARTS IDENTIFIER HARDWARE (ACTUAL SIZE MAY VARY) DESCRIPTION (EXTRA PIECES MAY BE INCLUDED) QTY. [. . . ] ATTACH THE TWO END PANELS P2 TO THE SIDE PANELS P1 AS SHOWN IN figure 2. REMEMBER THE GROOVE MUST FACE INWARD TOWARD THE PLAYFIELD. ATTACH THE END PANELS WITH BOLTS H6 AND WASHERS H7 INTO THE PRE-INSTALLED DOWEL CONNECTORS. TIGHTEN HARDWARE AT THIS TIME CAUTION: Do not over-tighten hardware!PLACE THE PLAYFIELD SUPPORTS P5 ON THE BOTTOM OF THE PLAYFIELD. INSERT SUPPORT RODS H3 THROUGH THE HOLES IN THE SIDE PANELS AND THE GROOVE IN THE PLAYFIELD SUPPORTS P5 AS SHOWN IN figure 3. PLACE WASHER H4 AND LOCKING NUT H5 ON EACH END OF SUPPORT RODS H3. P1 STEP 4 P3 P2 P1 H7 H6 FIGURE 2 STEP 5 H4 P5 H3 H5 FIGURE 3 9 ASSEMBLY INSTRUCTIONS SOCCER TABLE ASSEMBLY WARNING: TWO ADULTS NEEDED TO ASSEMBLE SOCCER TABLE 6. THE LEGS ARE ATTACHED WITH BOLTS H1 AND WASHERS H2. THE THREADED T-NUTS ARE PRE-ASSEMBLED IN THE LEGS. TIGHTEN HARDWARE AT THIS TIME. CAUTION: Do not over-tighten hardware! WARNING: This step requires two adults!Very carefully turn the table over and set on its legs. Be careful. The table is very heavy and the rods will slide. Do not lift the table by holding onto the rods. P4 STEP 6 P5 P4 P4 P4 H1 H2 FIGURE 4 10 H4 H5 0120-C10 ASSEMBLY INSTRUCTIONS SOCCER TABLE ASSEMBLY WARNING: TWO ADULTS NEEDED TO ASSEMBLE SOCCER TABLE 7. ATTACH BALL CATCHERS P9 TO THE SIDE PANELS AS SHOWN IN figure 5 USING SCREWS H8. SLIDE THE HANDLES P7 ONTO THE END OF THE RODS WITH THE HOLE CLOSE TO THE END. SLIDE THE RUBBER END CAPS P8 ONTO THE OTHER ENDS OF THE RODS. CAREFULLY CUT THE RUBBER BANDS THAT HOLD THE SPRING ASSEMBLIES TOGETHER ON THE RODS. HINTS: If the rods do not slide freely you can spray furniture polish on a rag and wipe down the rods. If the playfield has a slight warp you can loosen the nuts H5 on the rods H3 to help relax the playfield. P8 P7 STEPS 7&8 P9 H8 FIGURE 5 11 P8 P7 GAME RULES TABLE SOCCER Table soccer is also called "foosball. " It can be played by two teams of four players each or by two individuals: The Object of the Game: To be the first team (or player) to score a predetermined number of points or to score the most points in given amount of time. [. . . ] Should this product become defective due to material or workmanship within the warranty period, contact our Customer Service Department. This warranty is not transferable and does not cover normal wear and tear, or damage caused by improper handling, installation, or use of this product. This warranty is also void if product is in any way abused, damaged, or modified from its original state, or if used for other than indoor residential use. [. . . ]