User manual ESCALADE SPORTS G01511

[. . . ] THEN READ EACH STEP BEFORE STARTING THAT STEP. TWO ADULTS ARE REQUIRED TO ASSEMBLE THIS GAME TABLE Tools Needed Philips Screwdriver Adjustable Wrench or Socket Set Furniture Polish and Cloth An electric screwdriver is helpful in assembly. However, please use extreme caution with an electric screwdriver because you could overtighten the hardware and strip the screws. IMPORTANT! Make sure you understand the following tips before you begin to assemble your soccer table. When installing parts that have more than one bolt, start ALL the bolts in that part by hand before tightening anything. When the table is complete the Goalie Rod should be on your left when standing on either side of the table. [. . . ] The assembly is done with the table up-side-down. This means everything is opposite until the table is turned right-side-up. If your table model has push on type handles you cannot pull them off once installed. Make sure the rods are correct and you are installing the handle on the correct end of the rod. Do not tighten hardware until the instructions indicate so. Do not overtighten hardware, as you could damage the finish on the table 6. Some drawings or images in this manual may not look exactly like your product. You can apply spray furniture polish to a cloth and wipe down the rods to make them slide more easily in the bearings. READ AND FOLLOW ALL ASSEMBLY, OPERATION, AND SAFETY INSTRUCTIONS CAREFULLY. AT LEAST TWO ADULTS ARE NEEDED TO PUT THIS GAME TABLE TOGETHER! © 2002 Escalade Sports 2 For Customer Service Call 1-888-556-2759 © 2002 Escalade Sports 3 For Customer Service Call 1-888-556-2759 © 2002 Escalade Sports 4 For Customer Service Call 1-888-556-2759 © 2002 Escalade Sports 5 For Customer Service Call 1-888-556-2759 CAUTION: On the following page you will be assembling the main cabinet of your soccer table. Secure the ends of the playfield to the end panels with screws H7. © 2002 Escalade Sports 7 For Customer Service Call 1-888-556-2759 Figure 3 8. Attach one leg P4 at each table end as shown in FIGURE 4 using bolts H1 and washers H4 into the side panels and bolts H2 and washers H4 into the end panels. Next place the cross bar H10 between the legs and attach remaining legs to the soccer cabinet. Remember to start ALL bolts by hand before you tighten the legs. TIGHTEN ALL LEG HARDWARE AT THIS TIME. 9. Attach the ball catchers P8 to the side panels with screws H5. Center the catcher over the opening in the side panel. Attach the goal P9 to the end panel with screws H5. Center the goal over the opening in the end panel as shown in FIGURE 4. Attach the ball runner P11 between the ball catcher P8 and goal P9. Figure 4 10. [. . . ] Attach the ball runner P11 between the ball catcher P8 and goal P9. Figure 4 10. Screw one leg leveler H11 into the bottom of each leg. THIS STEP REQUIRES TWO OR MORE ADULTS. VERY CAREFULLY TURN THE TABLE OVER AND SET IT ON ITS LEGS. BE CAREFUL, THE TABLE IS VERY HEAVY AND THE RODS WILL SLIDE. [. . . ]