User manual ESCALADE SPORTS G01871

[. . . ] When the table is complete the Goalie Rod should be on your left when standing on either side of the table. The assembly is done with the table up-side-down. This means everything is opposite until the table is turned right-side-up. [. . . ] There will be four handles (one team) on each side of the table. Remember, the goalie rod is always in your left hand when the table is in the upright position and you are working upside down so it will be opposite during assembly. Figure 2 4. Once you are sure you have the players set up correctly, slide the other side panel P1 on the other end of the rods as shown. 5. Set the playfield P3 onto the assembly with the graphics facing down. 6. Attach the two end panels P2 as shown in FIGURE 3 using bolts H3 and washers H4. Remember to start all bolts by hand first before you tighten anything. MAKING SURE END PANELS ARE STRAIGHT AND FLUSH ALONG THE TOP AND BOTTOM TIGHTEN ALL HARDWARE AT THIS TIME. 7. Center the playfield in the cabinet and place the two playfield supports P7 on the playfield as shown. Slide playfield support rods H7 through the side panels and support braces as shown. Secure with finishing nut H8, and washer H4 on each end of the rod. Secure the playfield with screws H5 as shown. © 2002 Escalade Sports 6 For Customer Service Call 1-866-556-2759 Figure 3 8. Attach the ball catchers P10 to the side panels with screws H2. Center the catcher over the opening in the side panel. Attach the goal P11 to the end panel with screws H2. Center the goal over the opening in the end panel as shown in FIGURE 4. Attach the ball runner P13 between the ball catcher P10 and goal P11. 9. Slide the corner posts P5 in the corners as shown in FIGURE 4. Make sure you have the screw holes in the corner posts accessible for the next step. Figure 4 10. Attach the corner posts P5 with screws H10 as shown in FIGURE 5. Figure 5 CAUTION: Remember to start ALL bolts by hand in each leg before you tighten any of the hardware. 11. Attach the legs P4 with bolts H3 and washers H4 as shown in FIGURE 6. 12. Attach the leg levelers H1 as shown in FIGURE 6. Figure 6 © 2002 Escalade Sports 7 TIGHTEN ALL LEG HARDWARE AT THIS TIME. For Customer Service Call 1-866-556-2759 THIS STEP REQUIRES TWO OR MORE ADULTS. VERY CAREFULLY TURN THE TABLE OVER AND SET IT ON ITS LEGS. [. . . ] Passing If a ball is pinned on the 5-man rod, it cannot be passed to the 3-man rod of the same team without touching at least two player figures as it is being passed. Scoring When a ball enters the opposing team's goal, a point is scored. If the ball enters the goal, but bounces back onto the playing surface or leaves the table, it still counts as a goal. [. . . ]