User manual ESCALADE SPORTS G01872

[. . . ] When the table is complete the Goalie Rod should be on your left when standing on either side of the table. The assembly is done with the table up-side-down. This means everything is opposite until the table is turned right-side-up. [. . . ] There will be four handles (one team) on each side of the table. Remember, the goalie rod is always in your left hand when the table is in the upright position and you are working upside down so it will be opposite during assembly. 4. Once you are sure you have the players set up correctly, slide the other side panel P1 on the other end of the rods as shown. 5. Set the playfield P3 onto the assembly with the graphics facing down. Figure 2 Figure 3 6. Set the two end panels P2 as shown in FIGURE 3 and slide the four corner posts P7 into place. Make sure you align the holes on the corner posts with the holes on the side and end panels. 7. Center the playfield and secure to the end panels using screws H8. DO NOT OVER TIGHTEN SCREWS. © 2002 Escalade Sports 6 For Customer Service Call 1-866-556-2759 8. Attach the end panels to the side panels using bolts H3 and washers H4. 9. Place the playfield supports P5 onto the bottom of the playfield. Slide the cabinet rod H10 through the side panel and down the grove of the playfield supports. Attach the rod to the table using the finishing nuts H7 and washers H2 on each side of the table. Figure 4 MAKING SURE END PANELS ARE STRAIGHT TIGHTEN ALL HARDWARE AT THIS TIME. 10. Attach the legs P4 to the table as shown in FIGURE 5 using bolts H1 and washers H2. Remember to start ALL bolts by hand before you tighten the legs. TIGHTEN ALL LEG HARDWARE AT THIS TIME. 11. Attach the leg levelers H11 to the bottom of each leg as shown. Figure 5 © 2002 Escalade Sports 7 For Customer Service Call 1-866-556-2759 12. Attach the ball catchers P9 to the side panels with screws H5. Center the catcher over the opening in the side panel. Attach the goal P10 to the end panel with screws H5. Center the goal over the opening in the end panel as shown in FIGURE 6. Attach the ball runner P12 between the ball catcher P9 and goal P10. Figure 6 THIS STEP REQUIRES TWO OR MORE ADULTS. VERY CAREFULLY TURN THE TABLE OVER AND SET IT ON ITS LEGS. BE CAREFUL, THE TABLE IS VERY HEAVY AND THE RODS WILL SLIDE. DO NOT LIFT THE TABLE BY HOLDING ONTO THE RODS 13. [. . . ] Scoring When a ball enters the opposing team's goal, a point is scored. If the ball enters the goal, but bounces back onto the playing surface or leaves the table, it still counts as a goal. Spinning Rods Spinning the rods is illegal. [. . . ]