User manual ESCALADE SPORTS G01873

[. . . ] When the table is complete the Goalie Rod should be on your left when standing on either side of the table. The assembly is done with the table up-side-down. This means everything is opposite until the table is turned right-side-up. If your table model has push on type handles you cannot pull them off once installed. [. . . ] The handle end of the rod has a hole close to the end of the rod. There will be four handles (one team) on each side of the table. Remember, the goalie rod is always in your left hand when the table is in the upright position and you are working upside down so it will be opposite during assembly. 4. Once you are sure you have the players set up correctly, slide the other side panel P1 on the other end of the rods as shown. Figure 2 5. Set the playfield P3 onto the assembly with the graphics facing down. Attach the two end panels P2 as shown in FIGURE 3 using bolts H3 and washers H4. Remember to start all bolts by hand first before you tighten anything. 6. MAKING SURE END PANELS ARE STRAIGHT TIGHTEN ALL HARDWARE AT THIS TIME. 7. Center the playfield and secure to the end panels using screws H7. DO NOT OVER TIGHTEN SCREWS. Figure 3 © 2002 Escalade Sports 7 For Customer Service Call 1-866-556-2759 8. Carefully slide the corner posts P7 into the corners as shown in FIGURE 4. Use caution not to damage the laminate on the side and end panels as you slide the corners on. Make sure you have the screw holes in the corner post oriented as shown so they will be visable. 9. Attach the corner posts P7 to the side and end panels with screws H5. Figure 4 12. Attach the ball catchers P9 to the side panels with screws H5. Center the catcher over the opening in the side panel. Attach the goal P10 to the end panel with screws H5. Center the goal over the opening in the end panel as shown in FIGURE 5. Attach the ball runner P5 between the ball catcher P9 and goal P10. Figure 5 © 2002 Escalade Sports 8 For Customer Service Call 1-866-556-2759 10. Attach one leg at each table end as shown in FIGURE 6 using bolts H1 and washers H2 into the side and end panels. Next place the cross bar H10 between the legs and attach remaining legs to the soccer cabinet. Remember to start ALL bolts by hand before you tighten the legs. TIGHTEN ALL LEG HARDWARE AT THIS TIME. 11. Attach the leg levelers H9 to the bottom of each leg as shown. Figure 6 THIS STEP REQUIRES TWO OR MORE ADULTS. [. . . ] Passing If a ball is pinned on the 5-man rod, it cannot be passed to the 3-man rod of the same team without touching at least two player figures as it is being passed. Scoring When a ball enters the opposing team's goal, a point is scored. If the ball enters the goal, but bounces back onto the playing surface or leaves the table, it still counts as a goal. Spinning Rods Spinning the rods is illegal. [. . . ]