User manual ESCALADE SPORTS G0710

[. . . ] RAISE EACH P1B SECTION AND FASTEN THE HINGES P1G TO THE PLAYING SURFACE P1A WITH 1/2" PHILLIPS HEAD SCREWS H5. FASTEN LONG RAIL SECTIONS P1A AND P1B TO EACH SHORT RAIL SECTIONS P1C, P1D AND P1E WITH FLAT HEAD PHILLIPS SCREWS H3. H5 H3 P1B P1C P1A P1D P1C P1E H3 P1F P1G 8 0710-PR1 ASSEMBLY INSTRUCTIONS POOL TABLE ASSEMBLY WARNING: TWO ADULTS NEEDED TO ASSEMBLE POOL TABLE 5. USING BOLTS H1, WASHERS H7, LOCKWASHERS H9 AND NUTS H11, ATTACH LEG P2A TO LONG RAIL SECTION P1A AND SHORT RAIL SECTION P1C WITH HOLES CLOSEST TO RETURN END P1D. THEN ATTACH LEG P2B TO LONG RAIL SECTION P1B AND SHORT RAIL SECTION WITH HOLES P1C CLOSEST TO RETURN END P1D. [. . . ] POSITION APRON SIDE PANELS P7A AND P7B AS SHOWN AND ATTACH TO PLAYING SURFACE P1G USING PHILLIPS FLAT HEAD SCREWS H3. BOARD IS POSITIONED CORRECTLY WHEN APRON CORNER P10 RESTS INSIDE CORNER CAPATTACHED TO MAIN ASSEMBLY P1. SLIDE THE APRON END PANEL P8 INTO EACH APRON CORNER P10 AND FASTEN USING PHILLIPS HEAD SCREWS H5 AND TO THE PLAYING SURFACE P1G USING FLAT HEAD PHILLIPS SCREWS H3. SLIDE LONG RETURN BOARD P6A INTO THE GROOVES OF THE APRON SIDE PANELS P7A AND LONG RAIL P1A. REPEAT ON OTHER SIDE BY SLIDING LONG RETURN BOARD P6B INTO THE GROOVES OF THE APRON SIDE PANELS P7B AND LONG RAIL P1B. NOTE: RUBBERIZED SIDES OF THE LONG RETURN BOARDS P6A AND P6B SHOULD FACE TOWARDS THE MAIN ASSEMBLY P1. (UPWARDS WITH TABLE UPRIGHTED) WITH ANGLED CORNERS TOWARDS APRON CORNERS P10. P10 P7A P8 P1B P10 P6A P1A P1G P6B P1B 13 P7B ASSEMBLY INSTRUCTIONS POOL TABLE ASSEMBLY WARNING: TWO ADULTS NEEDED TO ASSEMBLE POOL TABLE 14. ATTACH AN APRON CORNER P10 TO EACH END OF THE APRON BALL RETURN PANEL P9 USING PHILLIPS HEAD SCREWS H5. NOTE: POSITION APRON CORNERS P10 SO THE SCREW HOLE IS NOT IN LINE WITH GROOVE FOR APRON BALL RETURN PANEL P9. ATTACH THE ASSEMBLED APRON BALL RETURN PANEL P9 TO BOTH APRON SIDE PANELS P7A AND P7B USING PHILLIPS HEAD SCREWS H5 AND ATTACH TO PLAYING SURFACE P1A USING PHILLIPS FLAT HEAD SCREWS H3. MAKE SURE APRON BALL RETURN PANEL "GROOVE" IS AWAY FROM PLAYING SURFACE (DOWN IF TABLE IS UPRIGHTED). NOTE: A TOTAL OF THREE SCREWS WILL BE PUT IN APRON CORNERS P10 AT THIS END OF TABLE - ONE YOU WILL NOT BE ABLE TO REACH BECAUSE OF CORNER CAP. P7A H5 H3 P7B P9 P10 14 0710-PR1 ASSEMBLY INSTRUCTIONS POOL TABLE ASSEMBLY WARNING: TWO ADULTS NEEDED TO ASSEMBLE POOL TABLE 16. BEND SHORT RETURN BOARD P11 BY HAND AND INSERT INTO THE GROVES OF BOTH APRON SIDE PANELS P7A AND P7B BY SLIDING IN X DIRECTION. SLIDE IN THE Y DIRECTION INTO THE GROOVES OF THE APRON BALL RETURN PANEL P9. ATTACH THE SHORT RETURN BOARD P11 USING PHILLIPS HEAD SCREWS H4. POSITION THE METAL BRACKETS H6 AS SHOWN AND TAP DOWN INTO PLACE WITH A HAMMER. AFTER THE GLUE HAS DRIED AND IS SET (APPROXIMATELY 12 HOURS), TURN THE TABLE ASSEMBLY OVER TO RIGHT SIDE UP. PLACE A POOL BALL ON THE PLAYING SURFACE AND LEVEL THE TABLE BY TURNING THE LEG LEVELERS P5. P5 P7A P11 H6 X Y X P7B P9 15 GAME RULES BILLIARDS Billiards refers to games played on a rectangular table covered with felt; pool is the most popular billiards game in the United States. Billiards games may be played by two players, teams of two players each, or three players. In billiards, players attempt to drive object balls into the table's pockets by striking them with the cue ball. 8-BALL: The most commonly played billiards game is "8-ball". The object of this game is for one player (or team) to pocket either the balls numbered 1 to 7 (solid) of 9 to 15 (stripes). [. . . ] Players receive 1 point for each ball they pocket and 2 points for pocketing the 9-ball. CUT-THROAT: Cut-throat is a game for three players. The player who makes a successful break gets to choose which set of balls he wishes to play. The object of the game is to pocket your opponent's balls. 16 0710-PR1 90 DAY WARRANTY Manufacturer warrants to the original retail purchaser, this product to be free from defects in material and workmanship for a period of ninety (90) days from the date of purchase. [. . . ]