User manual ESCALADE SPORTS JR

[. . . ] The remedy of repair or replacement stated above is our exclusive remedy. Escalade Sports will not be liable for any other damages or expenses which may incur, including but not limited to incidental or consequential damages. Escalade Sports assumes no other obligations or liability on the part of the purchaser, and Escalade Sports neither assumes nor authorizes any other person to assume for it any other liability in connection with the goods sold. What is Not Covered by This Warranty · · · Any merchandise subjected to abuse, negligence, improper installation, vandalism, acts of God, alteration of product, or any other events beyond the control of Escalade Sports. Paint kits will be available to assist in normal maintenance. [. . . ] Day 5. Please read the following notes before you begin. (Just a few things we have learned through installer feedback) Note: It is very important for the installer to understand the necessity of the nylon washers provided in the hardware pack. These washers adequately space painted parts at all pivot points. Neglecting the use of these washers will result in rusted parts. Note: DO NOT over tighten pivot points. Over tightening pivot points will damage tubing and will make adjustment of system more difficult. Just remember: Good and snug is suflicieni at all pivot points. - refer to drawing to assist in assembly STEP 1. Assemble actuator sleeve onto actuator. Slide sleeve over actuator until holes match up. Insert spacer through holes and center spacer. Lay post on its side on two padded saw horses and assemble the following: Insert 1" bolt through I/2" split washer, l/2" Rat washer, l/2" nylon washer `and actuator. With post still on its side, attach lower arm. Make sure Goalrillamlettering on lower arm is not upside down. Align middle holes of lower arm with welded round tube located 21" from top of post. Insert 9" bolt through 112" flat washer, 112" nylon washer, lower arm, another nylon, post, another nylon, other side of lower arm, another nylon, another flat and l/2" lock nut. STEP 2. STEP 3. STEP 4. Do no1 tighten bolt at this time. Insert 9" bolt through 112" flat washer, I/2" nylon washer, lower arm, another nylon, actuator spacer, another nylon, other side of lower arm, another nylon, another flat and l/2" lock nut. Reminder: Do not over fighten pivof poinls. Align holes on narrow end of upper arm with welded round tubing located I" from top of post. Insert 9" bolt through l/2" Rat washer, l/2" nylon washer, upper arm, another nylon, post, another nylon, other side of upper arm, another nylon, another flat and l/2" lock nut. Reminder: Do nof over tighten pivot points. At this time you are ready to position the post upright onto the anchor system. Be sure the concrete has been allowed to cure for at least 3 days. If so, gather 3 capable persons and have them assist you in positioning post onto anchor system. [. . . ] Rinse backboard with lukewarm water again. To minimize scratches and minor abrasions to your backboard, apply a mild polish such as Johnson's Paste Wax, Novus Plastic, Polish #I or Mirror Glaze Plastic Polish. Strong cleansers will damage backboard and void warranty. Rim HANGING ON THE RIM WILL VOID YOUR WARRANTY. Rims are not warranted for any defects other than workmanship. [. . . ]