User manual ESCALADE SPORTS M01500

[. . . ] These numbers are located on the product, packaging, and in this owner's manual. Your Model Number: C 2005 Escalade Sports M01500 For Customer Service Call 1-888-996-2729 1 IMPORTANT!READ THIS MANUAL ALL THE WAY THROUGH BEFORE BEGINNING TO PUT YOUR GAME TABLE TOGETHER!THEN READ EACH STEP CLOSELY. IMPORTANT! THE DRAWINGS IN THIS MANUAL MAY BE EXAGGERATED OR MODIDIFIED TO SHOW DETAILS. TWO (2) ADULTS ARE REQUIRED TO ASSEMBLE THIS GAME TOOLS NEEDED Wrenches (L) and (M) included with the hardware Kit Philips Screwdriver Adjustable Wrench or Socket Set is helpful but not required. IMPORTANT Make sure you understand the following tips before you begin to assemble your game. [. . . ] Find the top of the ramp netting and slide over the FIGURE 4. 19 12 tubes as shown in 12 Figure:4 C 2005 Escalade Sports For Customer Service Call 1-888-996-2729 7 7. Slide tubes 12 into 10 as shown in FIGURE 5. 8. Slide two tubes 10 to the end of the 7 tubes. Using two 8 support tubes from an "X" between the rear uprights as shown in FIGURE 5 One tube will be on the . front of the uprights and one will be on the back. Attach the tubes at the bottom using bolts A, washers J and nuts K. At the top of the "X" attach tube 11 and Ramp Net 19 horizontally between the rear uprights using bolts D, washers J and nuts K. The 11 tube will be on the outside of the uprights. ONCE ALL TUBES ARE IN PLACE TIGHTEN ALL HARD WARE FROM THE PREVIOUS 5 STEPS. 12 J Washer Washer Lock Nut 10 11 19 11 D Bolt J K K J 8 7 D Lock Nut K A Bolt JWasher Figure:5 8 10. Attach the rim 13 to the backboard 9 and plate 16 and nuts K as shown in FIGURE and the backboard. 16 using bolts B, plastic spacer 6. The spacer goes between the rim 11. Peel the protective coating from the electronics 15 and attach them to the backboard 9 using bolts E , washer H and nuts I. Attach the sensors to the backboard using screws G . There are three sensors per rim. Peel the protective coatingfrom the backboard before attaching electroinics 9 Washer H Bolt E B Rim 13 Backboard Electronics 15 Bolt 17 I Lock Nut H Washer K G Screw 16 Plastic Spacer Plate Lock Nut Figure:6 G r e y Wi r e White Wire Brown Wire Black Wire C 2005 Escalade Sports For Customer Service Call 1-888-996-2729 9 12. Attach the backboard and ramp net to the frame using bolts C , washer J and nuts K as shown in FIGURE 7 except for the bottom hole on the backboard you will also attach the ramp as shown in DETAIL A. Make sure you put the ramp behind the horizontal bar 11. Ne t Detail A 9 Lock Nut K Washer 18 C Bolt J J 19 Velcro straps used when folding unit N 11 Lock Nut K J Vinyl ramp goes behind horizontal bar 11 Figure:7 Velcro strap 13. Sl de support tube 11 through the bottom of the ramp net and attach using i bolts A, washers J and nuts K as shown in FIGURE 7. Attach the velcro strap around the tubes under the backboard as shown. This is to be used to hold the unit together when folded in the storage position. 10 . To perform the test so the unit will function correctly, put a ball slowly into the top of the basket. The scorer will change from 88 to 11 as it reads the ball and will give an audible sound. If there is no reading on the scorer during this test or if it changes to an 11 with no ball near the rim, slowly turn the upper control knob and adjust the sensitivity. The control knobs are located on the back of the electronic scorer. Adjust sensitivity to read to ball as it pass through the front area of the rim. Repeat test from the bottom of the basket for the lower sensor. You may also need to move the unit if you cannot get it to adjust correctly. Sunlight or halogen lighting will have an effect on the sensors to where they may not work. [. . . ] ESCALADE SPORTS strongly recommends that the Product is insured for value prior to mailing. WARRANTY DISCLAIMERS: ANY IMPLIED WARRANTIES ARISING OUT OF THIS SALE, INCLUDING BUT NOT LIMITED TO THE IMPLIED WARRANTIES OF MERCANTABILITY FOR AND FITNESS FOR A PARTICULAR PURPOSE, ARE LIMITED IN DURATION TO THE ABOVE 90 DAY PERION. ESCALADE SPORTS SHALL NOT BE LIABLE FOR LOSS OR USE OF THE PRODUCT OR OTHER CONSEQUENTIAL OR INCIDENTAL COSTS, EXPENSES OR DAMAGES INCURRED BY THE CONSUMER OF ANY OTHER USE. [. . . ]