User manual ESCALADE SPORTS M01901

[. . . ] Call us at: 1-888-996-2729 FAX: 812-467-1399 YOU MUST HAVE YOUR MODEL NUMBER WHEN INQUIRING ABOUT PARTS. OR WRITE TO: ESCALADE SPORTS CUSTOMER SERVICE DEPARTMENT P. O. BOX 889 EVANSVILLE, IN 47706 When contacting Escalade Sports please provide model number, serial number (if applicable), and part number if requesting a replacement part. [. . . ] ATTACH THE LOWER BRACKETS TO THE FRAME USING 2 BOLTS H2, 2 NUTS H3. 15 ATTACH THE UPPER BRACKETS TO THE FRAME USING 2 BOLTS H2, 2 RAMP NET HOOKS P16 AND 2 NUTS H3. SEE DETAIL 2 . DETAIL 2 H2 STEPS 14, 15 P10 P16 H3 P11 P10 DETAIL 1 H3 H2 P11 For Customer Service Call 888-996-2729 18 ASSEMBLY INSTRUCTIONS GAME ASSEMBLY WARNING: TWO ADULTS NEEDED TO ASSEMBLE FOOTBALL GAME 16 ATTACH THE RAMP NET P15 AS SHOWN BELOW BY FIRST SLIDING THE NET OVER THE TOP TUBES P10 . STEP 16 P15 P15 For Customer Service Call 888-996-2729 19 ASSEMBLY INSTRUCTIONS GAME ASSEMBLY WARNING: TWO ADULTS NEEDED TO ASSEMBLE FOOTBALL GAME 17 ATTACH THE BACK OF THE RAMP NET USING VELCRO STRAPS AS SHOWN BELOW. 18 ATTACH THE TOP OF THE RAMP NET BEHIND BOTH TUBES P5 AND HOOK THE ELASTIC LOOPS AROUND HOOKS P16 . STEPS 17, 18 P16 For Customer Service Call 888-996-2729 20 ASSEMBLY INSTRUCTIONS GAME ASSEMBLY WARNING: TWO ADULTS NEEDED TO ASSEMBLE FOOTBALL GAME 19 SLIDE TUBE P5 THROUGH FRONT OF RAMP NET AS SHOWN. MAKE SURE YOU LOOP RAMP UNDER P5 PREVIOUSLY INSTALLED. ON THE RIGHT SIDE ATTACH WITH BOLT H2 AND NUT H3. ON THE LEFT SIDE ATTACH WITH BOLT H2, SWITCH P14, WASHER H8 AND NUT H3 AS SHOWN IN DETAIL 2 . PLUG WIRE FROM P7A INTO BACK OF THE SWITCH. STEP 19 H3 H2 DETAIL 2 H3 H8 For Customer Service Call 888-996-2729 21 H2 ASSEMBLY INSTRUCTIONS GAME OPERATION After your assembly is complete, make sure you have all wire connections completely plugged in on the board and the switch. Next, plug the adapter into a suitable 110v outlet and plug the other end into the back of the switch. Find the ON / OFF button on the switch and turn the unit on. At this time, the electronic scorer will light up and begin making noise. Before you begin playing you will want to test the sensitivity of the shock sensors on the unit. First, turn the sensitivity knob on the back of the scoring unit to low. Next, throw a ball at the cloth face intentionally missing one of the holes. [. . . ] SUNLIGHT OR HALOGEN LIGHTING MAY HAVE AN EFFECT ON THE INFARED SENSORS PERFORMANCE. THE UNIT MAY NOT WORK CORRECTLY IF USED OUTDOORS, IN A GARAGE, OR ON A PATIO. TURN UNIT OFF AND UNPLUG WHEN NOT IN USE. [. . . ]