User manual ETON E1

[. . . ] www. etoncorp. com E1 MANUAL A M / F M / S H O RT WAV E / X M R E A DY R A D I O E1XM MANUAL E1 AM/FM/Shortwave/XM Ready Radio E1 DISPLAY DESCRIPTION (See page 16) FRONT PANEL DESCRIPTION (See page 11) 1 1 2 3 20 19 2 3 SIDE PANEL DESCRIPTION (See page 18) 18 4 5 6 7 8 9 4 17 16 15 5 6 7 8 14 13 12 11 10 9 DECLARATION OF CONFORMITY RESPONSIBLE PARTY : TEL: TRADE NAME: MODEL NUMBER: etón Corporation TOP PANEL DESCRIPTION (See page 15) 1 2 1015 Corporation Way Palo Alto, CA 94303 USA (650) 903-3866 etón Corporation E1 3 This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 1. This device may not cause harmful interference, and 2. This device must accept any interference received, including interference that may cause undesired operation. 1 E1XM MANUAL IMPORTANT SAFEGUARDS An appliance and cart combination should be moved with care. [. . . ] This will cause the notation "PRESS A OR B TO DELETE" to appear on the display. · Press "A" or "B" as appropriate. This will cause the notation "SELECT NUMBER to DELETE" to appearover the FAVORITES list. · Using the `Direct-Key-Input' keypad, press the number of the memory location containing the channel to be deleted. This will cause the selection to disappear from the memory list and "DELETED" to appear briefly over the FAVORITES list. E1 MENUS continued MAIN MENU 1. RADIO SETTINGS - Pressing `1' takes you to the RADIO SETTINGS menu which allows setting parameters for enhanced SSB, scan stop mode, FM band frequency range, MW band tuning step size, and whether the SW band is displayed in kilohertz (kHz) or megahertz (MHz). AUDIO SETTINGS - Pressing `2' takes you to the AUDIO SETTINGS menu which allows setting audio related parameters including mono / stereo output, entry beep on/off, power loss beep on/off, and squelch muting on/off. SET CLOCKS - Pressing `3' takes you to the SET CLOCKS menu. From this menu, the local and GMT clocks can be set. CLOCK MODES - Pressing `4' takes you to the CLOCK MODES menu. This menu allows setting various clock related parameters including auto clock set on/off, automatic daylight savings time compensation on/off, local time offset from GMT time, snooze time, and whether or not timers override the lock function. TIMERS - Pressing `5' takes you to the TIMERS menu. From this menu the start times, stop times, and memory channels for both event timers can be set. XM - Pressing `6' takes you to the XM menu if the receiver is in the XM mode. This menu allows XM antenna aiming, auto enter on/off, auto enter delay time selection, clearing favorite XM channels, clearing tagged XM channels, and access to diagnostic mode. If XM mode is not active when the XM menu is selected, an error beep will be heard and "ERROR" will appear on the MAIN MENU d isplay. When XM mode is not active, the XM menu will not be accessible. Unused Note: Regardless of whether the E1 is set to `XMALL', `CATEGORY', or `FAVORITE' channel selection modes, one can always go directly to any specific channel number using the Direct Key Input keys. Just enter the digits of the desired channel and then press either `ENTER' or the decimal point (`. '). E1 MENUS In the following discussion concerning menus, the numbers presented in front of each item refer to the keys on the Direct-Key- Input keypad. To activate a menu item, simply press the numbered key corresponding to the menu number. On keys that toggle between two conditions, the selected condition will appear in reverse video. MAIN MENU The MAIN MENU is the first menu encountered when the `MENU' softkey (left hand softkey below the display) is pressed. [. . . ] Use the `6' key to highlight the timer 2 mem ch and clear any entry that appears here using the CLEAR/LOCK and STORE keys. When finished, press the 9 key to exit the timer programming mode. Tune the E1 to the radio station that you wish to hear. Enable the timer with the instructions provided below. [. . . ]