User manual EUREKA SERIES

[. . . ] Upright Vacuum Cleaner Owner's Guide 4380 ­ 4480 Series Household Type Index Important Safeguards . . . . . . . . . . . . . . . . . 2 Service Information . . . . . . . . . . . . . . . . . . . . . 4 Assembly . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5-6 Thermal Cut Off . . . . . . . . . . . . . . . . . . . . [. . . ] NOTE: The dirt alert feature is not intended to be used for above the floor cleaning with attachments. The red light indicates dirt, dust, etc. is still being removed from the area being cleaned. How to Check the Dirt Alert Sensors To check if dirt sensor is working properly. While the red light is on, tip the vacuum backwards on rear wheels, lifting the brush roll off the carpet a couple of inches. After a few seconds the red light should turn off. HINT: New carpeting has loose carpet fibers which will trip the red light sensor beam. Hose Infrared emitter and sensor Hose Retainer 10 . HOW TO MAINTAIN The instructions in this booklet serve as a guide to routine maintenance. To avoid unnecessary service calls, check the cyclonic cassette, belt, and brush roll often. To Change Cassette Micron Filter: NOTE: Turn off the switch and unplug the electrical cord before changing the Cassette Micron Filter. Never operate the vacuum cleaner without the cyclonic cassette or the filter. 2 Remove cyclonic cassette by pushing up lever (1), unhooking (2) by swinging outward from vacuum body. When replacing cyclonic cassette, hook at top where shown (2), and swing back into place until lever (1) snaps into place. | Check and clean the Cassette Micron Filter once a month to maintain good performance. The filter can be cleaned by vacuuming with another cleaner or brushing dust off into the trash. Recommended changing of the Cassette Micron Filter is once every three months. || 3 2 To Change the Cassette Micron Filter: 1. Remove the filter frame by grasping the handle on the back of the filter frame and pulling firmly. The filter frame will drop down staying connected at the hinges on the bottom. Remove old filter from filter frame and replace with a new filter. Reconnect filter frame to cassette body by swinging filter frame up and pushing against cassette body until it snaps into place. 1. Cassette Body 1 Use GENUINE EUREKA replacement filter, 28115A. Look for the GENUINE EUREKA product symbol. | 1 | | 11 HOW TO MAINTAIN (continued) How To Empty Cyclonic Cassette NOTE: Turn off the switch and unplug the electrical cord before emptying cyclonic cassette. Never operate the vacuum cleaner without the cyclonic cassette or the filter. FOR INSTRUCTIONS ON HOW TO REMOVE THE CYCLONIC CASSETTE FROM THE CASSETTE BODY, REFER TO PAGE 11. Emptying the Cyclonic Cassette: It is clearly visible when the dust compartment is full and needs emptying. Lift screen as shown (3) to completely empty cyclonic cassette. It is possible to clean out the cyclonic cassette by using another vacuum. CAUTION: The cyclonic cassette can be washed in warm water, if desired, but strong detergents should not be used. [. . . ] Q: How can I be sure I am using only genuine Eureka products in my vacuum cleaner?A: Typically, packaged products and paper bags can be identified by a "Genuine Eureka Product" symbol (see illustration above). For further identification assistance, you may call our toll-free number, 1-800-282-2886, for the location of a nearby Eureka Authorized Warranty Station. Q: Are there any differences between "made to fit" or "imitation" and Genuine Eureka paper bags, belts, and parts? [. . . ]