User manual EUROFLEX EZ 2 SUPERCLEAN

[. . . ] EZ2-S SUPERCLEAN IMPORTANT: Before operating the unit for the first time, read these instructions carefully and keep them for future reference www. 3 05/10 Euroflex relieves itself of any liability for damages that shall be the result of improper use of the appliance, not in conformity with what’s written in this instruction manual. EZ2-S Steam Cleaner ENGLISH require further information or instructions not contained in this document. Dispose of plastic packaging appropriately, as it may represent a potential hazard for children! [. . . ] B 90° • Align the Handle Assembly screw hole with the opening in the steamer housing. Secure the handle assembly with self-tapping screw which was removed from bottom of Extension Tube (as shown in Fig. Attach Hard Surface Floor or Carpet Pad to Steamer Affix either the Hard Surface Floor Pad or Carpet Glide with Carpet Pad to your Floor Steamer. WARNING: To prevent floor damage, ALWAYS attach either the HARD SURFACE FLOOR PAD or the CARPET GLIDE ACCESSORY with CARPET PAD when using your Floor Steamer. NEVER use without either of these attachments affixed to the machine. ATTACHING HARD SURFACE FLOOR PAD Place Floor Pad face down on the floor, wide side forward, with white hook and loop strips facing up. Hold Floor Steamer about 2” above Pad and gently place Floor Steamer onto the Pad. Firmly press down to assure Pad is securely adhered to the Floor Steamer. aTTACHING CARPET GLIDE WITH CARPET PAD Place Carpet Glide face up on floor. Center and place Carpet Pad on top of Carpet Glide, wide side forward, with white hook and loop strips facing up. Hold Floor Steamer about 2” above Pad and gently place Floor Steamer onto the Pad. Firmly press down to assure Pad is adhered to the Floor Steamer and Carpet Glide is securely attached. uSE ON HARDWOOD FLOORS For hardwood floors , use only on “sealed” hardwood surfaces. Carefully control the amount of steam usedwhen cleaning, as too much water could cause damage IMPORTANT NOTE ABOUT LINOLEUM FLOORING Steam can cause wax to be stripped from, and consequently damage, some varieties of linoleum flooring. ALWAYS test a small, inconspicuous portion of the floor BEFORE using steam to ensure that your linoleum floor does not have this issue. Filling Boiler with Water WARNINGS: • Carefully read all instructions before removing Boiler Cap. €¢ Always unplug appliance before filling the Boiler. Follow these instructions to avoid overfilling the Boiler. €¢ Be sure appliance is unplugged, and has cooled for at least 10 minutes before filling with water. €¢ Make sure Handle Assembly is in the upright “off” position. Remove Boiler Cap by pressing it down and turning it counterclockwise. IMPORTANT If re-filling the Boiler while Steamer has been in use, be sure to allow Steamer to cool for at least 10 minutes and loosen Boiler Cap slowly to allow any excess steam to escape before com-pletely removing Cap. [. . . ] The Floor Steamer will stop producing steam when the Boiler is empty. When this happens, refill with water per instructions (see step 2D, “Refilling Boiler During Use”) or unplug and store unit. Use care when opening Boiler Cap as it may still be hot and steam may escape, causing burns. When clean drops of water appear, wipe clean with soft cloth. [. . . ]