User manual EUTECH INSTRUMENTS ECOSCAN TEMP 456 TEMPERATURE METER

[. . . ] MEASUREMENT 4. 1 4. 2 4. 3 4. 4 4. 5 Taking Measurements Displaying Maximum and Minimum Readings Holding a Reading Releasing a Held Reading Maximum and Minimum Hold Mode 10 10 10 11 11 10 5. RETURN OF ITEMS 12 13 13 14 15 16 17 Instruction Manual Temp 4/5/6 1. INTRODUCTION 1. 1 Introducing the economy series Thank you for purchasing the Temp 4/5/6 meter. These microprocessor-based handheld meters are economical and easy to use. [. . . ] The LCD shows "CA" momentarily and a value flashes. Press MAX/ or MIN/ key to adjust the displayed value until it matches the correct temperature. The MAX/ or MIN/ key will scroll to the maximum allowable value. NOTE: The maximum adjustments allowed are ±5 °C from factory default. 7 Instruction Manual Temp 4/5/6 6. The LCD displays "CO" momentarily, and the meter then reverts to measurement mode. See figure below. Press down CAL key for 5 seconds before release °C CAL °C From measurement mode °C HOLD ENTER °C 8 Instruction Manual Temp 4/5/6 3. 1. 2 Temperature Curve Selection (Temp 5 Meter Only) In the event temperature probe has drifted too far from its original characteristic ­ due to age and use or if the probe is being replaced, it may be a good idea to match probe to the best curve. There are 3 curves programmed in the unit. To choose the curve, proceed as follows: 1. Connect your temperature probe to the meter. Dip the probe in a constant temperature bath or a liquid whose temperature can be checked with a thermometer known to be accurate. For best accuracy, place the probe and thermometer in a constant temperature bath. Make sure that the meter is in the measurement mode. Press CAL key for 5 seconds to enter calibration mode. The LCD shows "CA" and the reading flashes. Press C/ F key to enter curve selection mode. Press the C/ F key again to scroll through three temperature curves (low, mid. Each press will take you through one curve. Choose the curve which gives you a reading closest to the actual value (of the bath or thermometer). Press ENTER key and the curve selection is complete. The unit will display "CO" and revert to the temperature calibration mode, with the display still flashing. Press and key to make fine adjustment until the display shows the correct desired temperature. The and key will scroll to the maximum o allowable value (maximum adjustment is ±5 C from factory default). [. . . ] Eutech Instruments/ Oakton Instruments will determine if the product problem is due to deviations or customer misuse. Out of warranty products will be repaired on a charged basis. Exclusions The warranty on your instrument shall not apply to defects resulting from: · · · Improper or inadequate maintenance by customer Unauthorised modification or misuse Operation outside of the environment specifications of the products 16 Instruction Manual Temp 4/5/6 11. RETURN OF ITEMS Authorisation must be obtained from our Customer Service Department or authorised distributor before returning items for any reason. A "Return Goods Authorisation" (RGA) form is available through our authorised distributor. [. . . ]