User manual EWAVE EWGS1B

[. . . ] Make sure the appliance cools down completely before assembling, disassembling and cleaning. Do not let cord hang over edge of table or counter, or touch hot surfaces. Do not operate the steamer without filling the water reservoir. Always check the water level before and during operation. [. . . ] Pull the whole pole to its full extension and tighten the clips as shown in Figure 1. Put the hose onto the threaded hose base by turning the fitting on the end of the hose clockwise (See Figure 2). Hang the steam nozzle on the steam nozzle holder as shown in Figure 3. Figure 1 Figure 2 Figure 3 NOTE: The telescopic pole must be fully extended during steam operation to ensure smooth lining of the hose and provide a free flow of steam. 7 CAUTION: Always hang the steam nozzle on the steam nozzle holder when not in use to prevent steam from causing bodily injury or damage to surfaces. WARNING: Do not pull the hose with excessive force or damage will occur and causing steam leakage. Do not move the appliance by grasping the hose. ACCESSORY ASSEMBLY To attach fabric brush onto the steam nozzle: Figure 4 1. Turn off the steamer and wait until no steam emits from the steam nozzle. Align the pegs along the back of the accessory with the holes on the steam nozzle. Push until the brush is firm in place. CAUTION: Do not install the accessory while steam is emitting from the steam nozzle to avoid burns. Operating Instructions 1. Unplug the power cord and turn the switch to "OFF" position. Remove the water tank, turn it upside down, and unscrew the valve cap (See Figure 5). Fill the water tank with cool water and replace the valve cap. To prolong the lifetime of your steamer, it is recommended to use distilled or de-mineralized water. Place the water tank back into the unit and make sure it is sitting properly and securely in the 8 cavity. (See Figure 6) Do not let the steamer operate with a dry water tank, or the damage to the unit could occur. Verify that the light on the switch is illuminated. Steam should start flowing from the nozzle in approximately 45 seconds. When finishing with the steaming session place the switch to the "OFF" position and remove the plug from the outlet. Figure 5 Figure 6 PRESSING WITH STEAM 1. To steam a garment, place it on a clean, rust-free clothes hanger and place the hanger on the clothes hanger hook. Grasp the handle and place the steam nozzle at the bottom of the garment. Steam will rise along the inside and outside of the fabric, removing the wrinkles. Slowly slide the nozzle vertically from the bottom to the top of the garment (See Figure 7). Do not allow kinks to form in the hose at any time. Remove the nozzle from bottom to top on the garment and smooth the fabric with your free hand. [. . . ] If standing the water-vinegar solution becomes visible in the water reservoir's inlet hole, continue to pour to solution into the hose connector until the water reservoir is about half-full, near the top of hose. Drain the solution out of the water reservoir by removing the drain plug and allowing the liquid to drain into a sink or tub. Drain the solution out of the hose connector by tilting the unit over a sink or tub and pouring the water out of the hose connector. Pour clean water in the hose connector and water reservoir inlet and drain. [. . . ]