User manual FAGOR 2H-114

[. . . ] We contribute in the defence of the Environment. thus our packagins: • Are 100% recyclable. € Contain the smaller quantity of parts and possible material to facilitate thus the recycling. 4 5 84 TOURNEBROCHE Pour les fours munis d’un sélecteur de fonctions à 8 positions et d’une broche tournante, procéder de la manière suivante: 1 Placez le crochet de la broche « A » dans le support de broche « B » conformément à la figure 1, puis placez-le à l’intérieur du four selon figure 2. [. . . ] 1 Push the duration button then turn the button until the desired duration appears on the display. 2 Push the end of cooking button, then turn the button until the display shows the time at which you wish the cooking to end. Once the oven switches on, the end of cooking light will go off. 3 Carry out the rest of the steps for switching on the oven, “Operating the oven”. By following these instructions, the oven will be programmed. In the example, the oven will switch on 50 minutes before 14:30 and at 14:30 it will switch off automatically and will begin to beep. In orde to stop the beeping, push the button and push the same button again in order to cancel the manual mode. Do not forget to turn the oven switch to “0”. Should there be no-one at home, the beeping will cease after 2 minutes and the oven will remain switched off. NOTE:You may modify the end of cooking and duration times even when the oven is already on. In order to do this, use the and buttons and turn the button. We recommend that before definitively programming the oven, you carry out a trial programming. The programme may be cancelled by setting either the or button to 0:00. 120 TEMPERATURE CONTROL BY MEANS OF THE ROASTING SENSOR The temperature indicator is activated by inserting the sensor in the socket (located inside the oven, in the upper left front part). The temperatures that may be selected range from 30ºC to 99ºC. Once the probe is inserted, the screen will display the temperature 60ºC. The probes symbol and the temperature indicator will flash. 1 Push the temperature button and turn the button until the desired temperature appears. When the button is released, the temperature programme will begin. Carry out the rest of the steps for switching on the oven, “Operating the oven”. 2 The screen will display the real temperature detected by the sensor (for example 50ºC). The pre-established temperature may be viewed by pushing the temperature button. [. . . ] 138 INSTALLATION UNPACKING Carefully remove all the elements protecting the apparatus. The two brackets “A” in two parts of the oven must also be removed, as shown in the figure. A OVEN WITH HO PLATE CONTROLS 100 560 2 49 0 0 30 2 The unit´s measurements are as shown in the drawing. The hot plat unit should be installed first and left disconnected until the oven is installed. [. . . ]