User manual FAGOR 3CC-239E X

[. . . ] Ouvrez le support du plafonnier ou la grille posterieure de support du filtre anti-graisse. Fermez le support du plafonnier ou la grille posterieure de support du filtre anti-graisse. Before performing any maintenance operation, isolate the hood from the electrical supply by switching off at the connector and removing the connector fuse. [. . . ] Turn the center handle of the carbon filter in the clockwise direction until it locks in place. Refit the grease filters and the light cover support (or the grease filter support grates). Removing the carbon filter: Turn the center handle of the carbon filter in the counterclockwise direction and remove the filter from its seat 12 Push the B knobs inwards toward each other (in the "Open" direction as indicated on the plastic knob itself). To remove the grates completely, use the N spring fasteners, which act as pins to hold the grate in place (Fig. Open the light cover support or the rear grease filter support grate. Always replace burnt-out lamps with 40Watt max. Close the light cover support or the rear grease filter support grate. Before calling for customer service because the lighting system does not work, make sure that the lamps are screwed in tightly. When installed, the distance between hood and burners must be not less than 65 cm. -- The hood cannot be connected to flues of other appliances that run on energy sources other than electricity. -- When the hood is used at the same time of other appliances that run on energy sources other than electricity, provision must be made for an adequate supply of air. -- No food must be cooked flambé underneath the hood. The use of an unprotected flame is dangerous for the filters and could cause fires. Therefore, never use an open flame under the hood. When frying foods, never leave the pan alone because the cooking oil could flare up. -- Please , keep to the provisions of official directives regarding the question of fume discharge. [. . . ] Where an electrical plug is not provided (for direct connection to electrical network) place a standards approved bipolar switch with an aperture distance of not less than 3mm (accessible) from the contacts. The manufacturers are not liable for any problems caused by the user's failure to observer the above instructions. The air is cleaned by means of carbon filter (two filters) and then circulated back into the room. [. . . ]