User manual FAGOR 3CFT-MINI TILE

[. . . ] the flaming of foods beneath the hood itself is severely prohibited. The use of exposed flames is detrimental to the filters and may cause a fire risk, and must therefore be avoided in all circumstances. Any frying must be done with care in order to make sure that the oil does not overheat and burst into flames. As regards the technical and safety measures to be adopted for fume discharging it is important to closely follow the relations provided by the competent authorities. [. . . ] Before re-connecting the hood circuit to the mains supply and checking the efficient function, always check that the mains cable is correctly assembled. Before beginning installation: Check that the product purchased is of a suitable size for the chosen installation area. To facilitate installation, remove the fat filters and the other parts allowed and described here, dismantle and mount it. This/these is/are to be mounted only if you want lo use the hood in the filtering version. Check (for transport reasons) that there is no other supplied material inside the hood (e. ), eventually removing them and keeping them. If possible, disconnect and move freestanding or slide-in range from cabinet opening to provide easier access to rear wall/ceiling. Otherwise put a thick, protective covering over countertop, cooktop or range to protect from damage and debris. select a flat surface for assembling the unit. Cover that surface with a protective covering and place all canopy hood parts and hardware in it. Disconnect the hood during electrical connection, by turning the home mains switch off. In addition check whether near the installation area of the hood (in the area accessible also with the hood mounted) an electric socket is available and it is possible to connect a fumes discharge device to the outside (only suction version). Carry out all the masonry work necessary (e. It securely with one screw and washer(7). Carry out electrical connections (8), but leave the hood disconnected from the general electrical main panel. Make sure that the carbon filter is already mounted on the back of the grease filter, or in case it's missing, buy it and install it. Use the high suction speed in cases of concentrated kitchen vapours. It is recommended that the cooker hood suction is switched on for 5 minutes prior to cooking and to leave in operation during cooking and for another 15 minutes approximately after terminating cooking. Expansion wall plugs are provided to secure the hood to most types of walls/ceilings. However, a qualified technician must verify suitability of the materials in accordance with the type of wall/ceiling. The wall/ceiling must be strong enough to take the weight of the hood. Do not tile, grout or silicone this appliance to the wall. [. . . ] Follow package directions and do not touch new light with bare hands. If the lights do not work, make sure that the lamps are fitted properly into their housings before you call for technical assistance. Cleaning: the panel should be cleaned with the same frequency as the fat filters, using a cloth soaked in neutral liquid detergents. Always check that the panel is fixed in its place well. [. . . ]