User manual FAGOR 3CFT-TILE

[. . . ] select a flat surface for assembling the unit. Cover that surface with a protective covering and place all canopy hood parts and hardware in it. Disconnect the hood during electrical connection, by turning the home mains switch off. In addition check whether near the installation area of the hood (in the area accessible also with the hood mounted) an electric socket is available and it is possible to connect a fumes discharge device to the outside (only suction version). [. . . ] Only for chimney installation: In case you want to use the hood in filtering version, fasten the deflector F to the support bracket, and connect the other side of the tube to the connection ring placed on the deflector (13). Apply the chimneys and fasten them on with two screws (14a) to the chimney support bracket , , G" (14b). And make the lower part of the chimney slide into the suited part on top of the chimney. If the hood has to be used in extractor version, remove, if supplied, the carbon filter and the fastening wand (placed on the back of the grease filters ­ see relative paragraph). If the hood has to be used in filtering version, make sure that the carbon filter is already mounted on the back of the grease filter, or in case it's missing, buy it and install it. Operation during cooking and for another 15 minutes approximately after terminating cooking. Light key ON/OFF Intensive speed selection key (suction power) - duration 5 minutes - press again to return to previous setting. Medium-speed selection key (suction power) - when flashing it indicates the need to wash or replace the carbon filter. At first only key 1 will flash and then both keys 1 and 2 to indicate activation. repeat the operation to deactivate the signal. At first keys 1 and 2 will flash and then only key 1 to indicate deactivation. Low-speed selection key (suction power) ­ when flashing it indicates the need to wash the fats filter. RESET FILTERS SIGNALS After having carried out maintenance of the filters, press the key for 3 seconds. This function can be useful during the product cleaning operations. just repeat the operation to reinsert the electronics. The perimeter suction panel must always be left closed and opened only for maintenance (e. If the hood fails to operate correctly, briefly disconnect it from the mains power supply for almost 5 sec. Then plug it in again and try once more before contacting the Technical Assistance Service. Use the high suction speed in cases of concentrated kitchen vapours. Before performing any maintenance operation, isolate the hood from the electrical supply by switching off at the connector and removing the connector fuse. Or if the appliance has been connected through a plug and socket, then the plug must be removed from the socket. The rods are included in the carbon filter packing and not on the hood. [. . . ] To remove the grease filter, pull the spring release handle. The charcoal filter can be washed once every two months (or when the filter saturation indication system ­ if envisaged on the model in possession ­ indicates this necessity) using hot water and a suitable detergent, or in a dishwasher at 65°C (if the dishwasher is used, select the full cycle function and leave dishes out). Eliminate excess water without damaging the filter, then put it in the oven for 10 minutes at 100° C to dry completely. Replace the mattress every 3 years and when the cloth is damaged. [. . . ]