User manual FAGOR 5H-730X

[. . . ] Introduction What does your oven look like?Safety recommendations How do you install your oven?Close-up of your programmer How do you set the clock on the oven?How do you program for immediate cooking? [. . . ] The fuse in your set-up must be 16 amperes. The electrical connection should be performed before the appliance is installed in the cabinet. The oven must be connected with a power cable (standardised) with three 1. 5 mm2 conductors (1 ph +1 N + ground) that must be connected to a monophase 220-240 V network via a IEC 60083 standardised receptacle (1 ph +1 N + ground lead) or an all-pole cut-off device with a minimum distance between contact openings of 3 mm. The safety wire (green-yellow) is connected to the appliance's terminal and must be connected to the ground lead of the electrical set-up. In the case of connections with an electric receptacle, it must remain accessible after installation of the appliance. The power cable (H05 RR-F, H05 RN-F or H05 VV-F) must be of sufficient length to be connected to the build-in oven while it sits on the floor in front of the cabinet. To do this the appliance must be disconnected from the electrical network: · Open the inspection flap located at the lower right of the back cover by unscrewing the two screws, then pivot the inspection flap. Strip 12 mm along each wire of the new power cable. Loosen the screws from the terminal board and remove the power cord to be replaced. Introduce the power cable through the side of the cover in the cable clip located to the right of the terminal board. Connect the power cord wires in accordance with the written markings on the terminal board. The green-yellow coloured ground wire should be connected to the terminal. Screw down tightly the screws on the terminal board and check the connection by pulling on each wire. Close the inspection flap using the two screws. We cannot be held liable for any accident resulting from an inexistent, defective or incorrect ground lead. Disconnect your oven before performing any task on the bulb to avoid the risk of electric shock and, if necessary, let the appliance cool down. Bulb specifications: - 15 W - 220-240 V - 300°C Unscrew - E 14 cap View port c) Replace the bulb then reposition the view port and reconnect your oven. To unscrew the view port and the light, use a rubber glove, which will make disassembly easier. The oven can be installed under a work top or in a column of cabinetry (open* or closed) having the appropriate dimensions for built-in installation (see adjacent diagram). Your oven has optimised air circulation that allows it to achieve remarkable cooking and cleaning results if the following guidelines are respected: · Centre the oven in the cabinet so as to guarantee a minimum distance of 5 mm between the appliance and the neighbouring cabinet. The material of the built-in cabinetry must be heat resistant (or be covered with such a material). [. . . ] When cooking begins, the cooking end time programme icon is no longer displayed. At the end of cooking (end of programmed time), - The oven stops, - The cooking time icon is no longer displayed, - 0:00 is displayed - A series of beeps is emitted for a few minutes. The beeps are definitively deactivated by pushing on any touch control, when the display also returns to the time of day. Please note: at this moment, your oven begins to heat up. [. . . ]